Abstract:With the rapid development and broad applications of unmanned aerial vehicle (UAV)-based wireless stations in the sky, fundamental understanding and characterization of the realistic air-to-ground (A2G) communication link properties are crucial. In this article, a UAV-aided channel sounder with a real-time processing hardware system is developed for highly dynamic and nonstationary A2G channel measurements. In the hardware system, a global positioning system (GPS)-based triggering signal is designed, the equivalent antenna pattern affected by the UAV airframe is considered, and an appropriate sounding signal is selected, to improve the accuracy of measured channel impulse response (CIR). Moreover, real-time hardware processing algorithms for raw channel data, that is, CIR extraction, system response elimination (SRE), power loss recovery (PLR), and adaptive multipath component (MPC) recognition are developed and implemented on a single field-programmable gate array (FPGA) chip. In this way, the required storage size of channel data and the processing time for one slice of CIR is greatly decreased, which can meet the requirement of nonstationary A2G channel measurement with a high sampling rate and long-time measurement. A commercial channel emulator is used to reproduce controllable channels and verify the performance of the developed channel sounder. Finally, the developed channel sounder is applied to carry out A2G measurement campaigns at 3.5 GHz in a campus scenario. The channel characteristics, that is, path loss (PL), -factor, and path angle are analyzed. The measured channel characteristics are consistent with existing measurements under a similar scenario. The estimated path angles are also validated by the theoretical results. Thus, the channel sounder can be used to capture the nonstationary A2G channel characteristics for the system design and algorithm optimization of A2G commun- cations.

On-Grid 3D Dynamic Channel Tracking for Space-Air Communications with Multiple UAVs

3D on and Off-Grid Dynamic Channel Tracking for Multiple UAVs and Satellite Communications

3D Channel Tracking for UAV-Satellite Communications in Space-Air-Ground Integrated Networks

Three-Dimensional Non-Stationary Geometry-Based Modeling of Sub-THz MIMO Channels for UAV Air-to-Ground Communications.

Communication and Trajectory Design in UAV-enabled Flying Network.

Spatial Information Aided Joint UL/DL Channel Tracking for Massive MIMO System in HST Environment

Deep Learning for Channel Tracking in IRS-Assisted UAV Communication Systems

Time Varying Channel Tracking for Multi-UAV Wideband Communications with Beam Squint.

Channel Tracking with Flight Control System for UAV Mmwave MIMO Communications

Low-Complexity Joint Resource Allocation and Trajectory Design for UAV-Aided Relay Networks With the Segmented Ray-Tracing Channel Model

A Non-Stationary Channel Model for 6G Multi-UAV Cooperative Communication

Dual-Functional UAV-Empowered Space-Air-Ground Networks: Joint Communication and Sensing

Three Dimensional Modeling And Space-Time Correlation For Uav Channels

Channel Modeling and Characteristics Analysis under Different 3D Dynamic Trajectories for UAV-Assisted Emergency Communications

Integrating Communications and Control for UAV Systems: Opportunities and Challenges

A UAV-Aided Real-Time Channel Sounder for Highly Dynamic Nonstationary A2G Scenarios

UAV-RIS-Aided Space-Air-Ground Integrated Network: Interference Alignment Design and DoF Analysis

Air-to-ground 3D channel modeling for UAV based on Gauss-Markov mobile model

A Novel 3D UAV Channel Model for A2G Communication Environments Using AoD and AoA Estimation Algorithms

On the Interplay between Sensing and Communications for UAV Trajectory Design

A Novel 3D Non-Stationary Geometry-based MIMO Channel Model for UAV-Ground Communication Systems