A two-phase flow model coupled with geomechanics for simulating transient production behaviour in an unconventional reservoir by considering fracture geometry and capillary pressure

Yunhao Zhang,Daoyong Yang

DOI: https://doi.org/10.1016/j.fuel.2024.130959

IF: 7.4

2024-02-08

Fuel

Abstract:A robust and efficient two-phase flow model integrated with geomechanics has been developed, validated, and subsequently utilized to investigate the transient flow characteristics in an unconventional reservoir with consideration of fracture geometry and capillary pressure. As for a fracture subsystem, various hydraulic fracture (HF) geometries are applied to capture a loss in the fracture conductivity due to an alteration in the effective normal stress on the fracture surface during the flowback period. Different from the traditional treatment by assuming it as a constant, a function of interfacial tension between gas and water as well as fracture aperture is employed to obtain the capillary pressure within a fracture, during which the gas/water saturation and the fracture aperture in each fracture segment with an equal length can be iteratively obtained and updated. Not only does the proposed model offer the flexibility to investigate the effects of dynamic fracture properties (i.e., aperture and conductivity) and capillary pressure on the two-phase flow behaviour in the fractures with various fracture geometries, but also its precision has been validated through numerical simulations and subsequently applied in the field cases with outstanding performance. Dynamic fracture properties and capillary pressure are found to exert considerable influences on the gas/water daily production rates and cumulative production at the early time flow. It is worthwhile noting that capillary pressure shows a more pronounced effect on the transient flow behaviour due to a reduction in fracture aperture during production. Moreover, the fracture with a triangular shape exhibits the lowest gas/water production rate, whereas a rectangular fracture results in the largest gas/water production rate. On the basis of fracture geometry and geomechanics, the former shows the smallest deformation induced by the effective stress, and the latter suffers the largest deformation under the same stress condition. In addition, a poorly propped HF exhibits a large aperture reduction, resulting in a reduction in gas/water production rate. As for field cases, the gas/water production rate obtained from the two-phase flow model demonstrate a strong agreement with the observed data, providing further confirmation of the dependability and robustness of the proposed model.

energy & fuels,engineering, chemical