Abstract:Powered by renewable electricity, the electrochemical conversion of CO2 to liquid fuels and valuable chemicals is a meaningful approach to enable carbon cycling and tackle environmental issues. An intrinsic challenge has been the low efficiency and selectivity, in particular for deep reduction products. Here, we report on an interface-enhanced strategy for transforming the catalytic selectivity toward the CO2 reduction reaction (CO2RR). Inspired by the enzyme catalysis in nature, where the catalytic center is surrounded by a chemically selective environment, we create a thin layer of nitrogen-doped carbon (NxC) over the Cu surface. The NxC environment does not modify the electronic property of Cu but selectively enriches and activates CO2 molecules through the specific N–CO2 interaction, as experimentally identified. Such a Cu/NxC interface has boosted the faradic efficiency (FE) of the CO2RR to be above 90%, with the C2 products (ethylene and ethanol) being the majority (80% in total FE). The NxC overlayer also protects well the Cu substrate from the morphological change, thus increasing the catalytic stability. Our findings manifest that the chemical environment over the metal surface indeed plays a crucial, but not well recognized, role in selectivity control, which can hardly be achieved by solely tuning the electronic structure of metal catalysts.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acscatal.0c03846?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acscatal.0c03846</a>.Illustration of the xC catalyst; STEM image in <a class="internalNav" href="#fig1">Figure </a><a class="internalNav" href="#fig1">1</a>c was filtered using Richard–Lucy deconvolution; ECSA measurement of Cu disk electrode; N2 sorption test for Cu NPs, , and xC catalysts; the measured double layer capacitances; the quantitative analysis of Cu, C, and N species by electron-probe microanalyzer (<a class="ext-link" href="/doi/suppl/10.1021/acscatal.0c03846/suppl_file/cs0c03846_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Ultrastable Cu Catalyst for CO2 Electroreduction to Multicarbon Liquid Fuels by Tuning C–C Coupling with CuTi Subsurface

Electrocatalytic Reduction of CO2 with Enhanced C2 Liquid Products Activity by the Synergistic Effect of Cu Single Atoms and Oxygen Vacancies

Electrocatalytic reduction of CO 2 with enhanced C 2 liquid products activity by the synergistic effect of Cu single atoms and oxygen vacancies

Stabilizing Cu+ Species in Cu2O/CuO Catalyst via Carbon Intermediate Confinement for Selective CO2RR

Multi‐Shell Copper Catalysts for Selective Electroreduction of CO2 to Multicarbon Chemicals

Role of single-atom alloy catalysts in electrochemical conversion of carbon dioxide: A theoretical study

Establishing Non-Stoichiometric Ti4O7 Assisted Asymmetrical C-C Coupling for Highly Energy-Efficient Electroreduction of Carbon Monoxide

A Reconstructed Cu2P2O7 Catalyst for Selective CO2 Electroreduction to Multicarbon Products

Multicarbons generation factory: CuO/Ni single atoms tandem catalyst for boosting the productivity of CO2 electrocatalysis

Interface-Enhanced Catalytic Selectivity on the C 2 Products of CO 2 Electroreduction

Protecting Copper Oxidation State Via Intermediate Confinement for Selective CO2 Electroreduction to C2+ Fuels

Mg-Doped Cu Catalyst for Electroreduction of CO2 to Multicarbon Products: Lewis Acid Sites Simultaneously Promote *CO Adsorption and Water Dissociation

Efficient CO2 Electroreduction to Multicarbon Products at Cusio3/Cuo Derived Interfaces In Ordered Pores

Direct Low Concentration CO2 Electroreduction to Multicarbon Products Via Rate-Determining Step Tuning

Cold plasma activated Cu–Co multi-active centers tandem catalysts for efficient electrocatalytic CO2 into C2H4

Ultralow Ag-assisted carbon-carbon coupling mechanism on Cu-based catalysts for electrocatalytic CO 2 reduction

Mg-Doped Cu Catalyst for Electroreduction of CO 2 to Multicarbon Products: Lewis Acid Sites Simultaneously Promote *CO Adsorption and Water Dissociation

Enriching the Local Concentration of CO Intermediates on Cu Cavities for the Electrocatalytic Reduction of CO2 to C2+ Products.

A tin-based tandem electrocatalyst for CO 2 reduction to ethanol with 80% selectivity

Electron‐Deficient Cu Sites on Cu3Ag1 Catalyst Promoting CO2 Electroreduction to Alcohols

Coupled Metal/Oxide Catalysts with Tunable Product Selectivity for Electrocatalytic CO2 Reduction