Abstract:The Atlantic razor clam exhibits exceptional penetration performance in wet sands by periodically expanding and contracting its shell and foot during burrowing. Essentially, this periodic penetration movement can be simplified as a cyclic alternation of cylinder expansion and cone penetration, which are analogous to the geotechnical pressuremeter test and the cone penetration test. The dynamic penetration movement of the razor clam was simplified as four major connective steps—cylinder expansion, cone penetration, cylinder contraction, and cylinder retraction—and the kinematics was parameterized based on the biological data. Using a simplified and idealized synthetic dry sand sample, we attempted to model the clam-inspired penetration process using two common geomechanics tools, an analytical model based on cavity expansion theory and a numerical discrete element method (DEM), and to showcase the advantages and limitations of these two approaches in the dynamic penetration modeling. In the analytical model, the four consecutive steps were assumed to be independent. The penetration resistance and energy consumption for each step were therefore roughly estimated using cavity expansion theory; in parallel, the independent cylinder expansion and cone penetration process as well as the clam-inspired coupled dynamic penetration process were also modeled using the DEM method. When the results were compared, it was found that the adopted cavity expansion theory solutions can predict the independent cylinder expansion and cone penetration behaviors, given that the parameters were carefully chosen and calibrated. However, it cannot capture the interference effect in a coupled dynamic penetration process. Specifically, the analytical model overestimates the cone penetration resistance of the coupled dynamic penetration process; the cylindrical shaft expansion causes stress release around the cone, leading to a reduction in the tip resistance as the cone continues to penetrate. The analytical model also underestimates the expansion pressure in the dynamic penetration process, which is attributed to the change in stress and fabric state caused by the cyclic expansion/contraction movement. Moreover, the clam-inspired dynamic penetration was found to reduce the energetic cost on the penetration of cone and shaft for about 36% and still maintain a slightly lower energy consumption with additional cost on the cyclic shaft expansion, compared with the pure cone penetration strategy. With a better future understanding of the highly effective and efficient self-burrowing behavior of natural burrowers, it is envisioned to develop self-burrowing robots for a spectrum of geotechnical applications.

Design and Analysis of a Novel and High-efficiency Axe-foot Part for Razor Clam Inspired Anchoring Robot.

Design and Analysis for the Axe Foot of Bio-inspired Anchoring Robot

A Novel and High-efficiency Razor Clam Inspired Burrowing Robot That Utilizes Localized Fluidization Mechanism

A Bioinspired Shape Memory Alloy Based Soft Robotic System for Deep‐Sea Exploration

Design and comparative analysis of self-propelling drill bit applied to deep-sea stratum drilling robot

Mechanical design and experimental research on locomotion characters of robot inspired by water strider

Design and Performance Analysis of a Tracked Wall-Climbing Robot for Ship Inspection in Shipbuilding

Design and Implementation of Multi-Level Linkage Mechanism Bionic Pectoral Fin for Manta Ray Robot

SBOR: a minimalistic soft self-burrowing-out robot inspired by razor clams

Micro-needle Dynamic Anchoring Foot Design for Underwater Drilling Robot.

Design, modeling and control of a miniature bio-inspired amphibious spherical robot

Development and Analysis of Digging and Soil Removing Mechanisms for Mole-Bot: Bio-Inspired Mole-Like Drilling Robot

Research and Implementation of Pneumatic Amphibious Soft Bionic Robot

Study on the Design and Experimental Research on a Bionic Crab Robot with Amphibious Multi-Modal Movement

Optimal Design and Motion Performance Analysis for the Novel Compound Amphibious Robot

Research on anchoring force of the deep-sea stratum drilling robot

Design of an actuator with bionic claw hook-suction cup hybrid structure for soft robot

Modeling Clam-inspired Burrowing in Dry Sand using Cavity Expansion Theory and DEM

Design and Analysis of the Bionic Mechanical Foot with High Trafficability on Sand

Design and Implementation of Small Modular Amphibious Robot System

Design and Workspace Analysis of Drilling Arm of Mining Anchor Drilling Robot