Abstract:With advanced digital technologies as the key support, many scholars and researchers have proposed various random warranty models by integrating mission cycles into the warranty stage. However, these existing warranty models are designed only from the manufacturer's subjective perspective, ignoring certain consumer requirements. For instance, they overlook a wide range of warranty coverage, the pursuit of reliability improvement rather than mere minimal repair, and the need to limit the delay in repair. To address these consumer requirements, this paper proposes a novel random collaborative preventive maintenance warranty with repair-time threshold (RCPMW-RTT). This model incorporates terms that are jointly designed by manufacturers and consumers to meet specific consumer needs, thereby overcoming the limitations of existing warranty models. The introduction of a repair-time threshold aims to limit the time delay in repairing failures and to compensate for any losses incurred by consumers. Using probability theory, the RCPMW-RTT is evaluated in terms of cost and time, and relevant variants are derived by analyzing key parameters. As an exemplary representation of the RCPMW-RTT, two random replacement policies named the discrete random renewable back replacement (DRRBR) and the discrete random renewable front replacement (DRRFR) are proposed and modelled to ensure reliability after the expiration of the RCPMW-RTT. In both policies, product replacement is triggered either by the occurrence of the first extreme mission cycle or by reaching the limit on the number of non-extreme mission cycles, whichever comes first. Probability theory is used to present cost rates for both policies in order to determine optimal values for decision variables. Finally, numerical analysis is performed on the RCPMW-RTT to reveal hidden variation tendencies and mechanisms; numerical analysis is also performed on the DRRBR and the DRRFR. The numerical results show that the proposed random replacement policies are feasible and unique; the replacement time within the post-warranty coverage increases as the maintenance quality improves and the cost rate can be reduced by setting a smaller repair-time threshold.

A Preventive Maintenance Policy with Usage-Dependent Failure Rate Thresholds under Two-Dimensional Warranties.

A Condition-Based Replacement and Spare Provisioning Policy for Deteriorating Systems with Uncertain Deterioration to Failure.

An Optimum Condition-Based Replacement And Spare Provisioning Policy Based On Markov Chains

The impact of gamma usage processes on preventive maintenance policies under two-dimensional warranty

Availability Optimization of Two-dimensional Warranty Products Under Imperfect Preventive Maintenance

Discrete Random Renewable Replacements after the Expiration of Collaborative Preventive Maintenance Warranty

A new cost-sharing preventive maintenance program under two-dimensional warranty

Designing warranty and maintenance policies for the product subject to random working cycles

An unpunctual preventive maintenance policy under two-dimensional warranty

Three-dimensional warranty and post-warranty maintenance of products with monitored mission cycles

Optimal Periodic Replacement Policy for a Warranted Product Subject to Multi Modes Failure Process

A study on two‐dimensional warranty with a preventive maintenance policy under burn‐in or run‐in

Design of a performance-based warranty policy with replacement–repair strategy and cumulative cost threshold

Optimization of joint preventive maintenance strategy for two-dimensional warranty equipment

Joint optimization of two-dimensional warranty period and maintenance strategy considering availability and cost constraints

A Two-Stage Preventive Maintenance Optimization Model Incorporating Two-Dimensional Extended Warranty.

Preventive Repair Policy and Replacement Policy of Repairable System Taking Non-Zero Preventive Repair Time

Optimization of a preventive maintenance strategy for a product with limited repair times

Optimal Inspection-Based Preventive Maintenance Policy for Three-State Mechanical Components under Competing Failure Modes

Control-Limit Preventive Maintenance Policies for Components Subject to Imperfect Preventive Maintenance and Variable Operational Conditions

Warranty Cost Model Based on Optimal Preventive Maintenance Operations for Repairable Products