Abstract:Background. Hemodynamic changes and consequent low-density lipoprotein (LDL) filtration play an important role in the atherosclerotic plaque development of coronary arteries. In this pilot controlled case study, we aimed to investigate the correlation between parameters derived from computational fluid dynamics (CFD) simulation and risks (both current and long-term) of coronary atherosclerosis. Methods. We reconstructed geometric models from the baseline computed tomography (CT) angiography of two subjects, one patient and one healthy control, and performed CFD simulations. We estimated the current risk of ischemia by fractional flow reserve (FFR). We estimated the potential risk of plaque development by wall shear stress (WSS) and LDL filtration rate with follow-up clinical imaging validation. We investigated the effects of simulation methods (transient/static) and rheological models (Newtonian/Carreau-Yasuda) by comparing the corresponding results (FFR, WSS and LDL filtration rate) in the patient's left anterior descending coronary artery. Results. In baseline CFD simulation, FFR indicated mild current ischemic risk of the patient, in accordance with existing angina pectoris. Baseline WSS and LDL filtration rate results were related with in vivo plaque development. The plaque-growth locations in follow-up CT angiogram coincided with areas of low WSS and high LDL filtration rate in the baseline simulation. The LDL filtration rate delineated more specific risky areas than WSS. Between transient and static results, the difference of FFR was less than 5% in the whole model. As to WSS and LDL filtration rate the transient/static difference was within 20% inmost areas, but rose up to 50% for WSS and even higher for LDL filtration rate, in areas with low WSS and high LDL filtration rate. As to rheological effects, Newtonian/Carreau-Yasuda difference was negligible for FFR throughout the model, within 30% for WSS and LDL filtration rate in major areas, and 50% or higher in certain segments where low. WSS and high LDL filtration rate existed. Conclusion. CFD results appeared to be related with in vivo development of coronary atherosclerosis. Simulated FFR and its threshold value 0.8 demonstrated the ischemic risk. Both WSS and LDL filtration rate could indicate areas of plaque growth.

Asymmetric Distribution of Pathogenic Low Wall Shear Stress of the Bilateral Subclavian Arteries: Two Case Reports

Estimating Current and Long-Term Risks of Coronary Artery in Silico by Fractional Flow Reserve, Wall Shear Stress and Low-Density Lipoprotein Filtration Rate

Experimental Study on Hemodynamics of an End-to-side Anastomosis

Effect of Asymmetrical Entry Velocity Profile on Outer Wall Shear Stress in Two Carotid Bifurcation Models

The effect of coarctation degrees on wall shear stress indices

The influence of blood velocity and vessel geometric parameters on wall shear stress

Numerical study of hemodynamic flow in the aortic vessel of Williams syndrome patient with congenital heart disease original article

Investigation of pulsatile flowfield in healthy thoracic aorta models

Abstract WP142: Investigating the Association of Intracranial Stenosis With Low Wall Shear Stress

Numerical Simulation of Blood Flow in Aortoiliac Bifurcation with Increasing Degree of Stenosis

Wall shear stress and pressure patterns in aortic stenosis patients with and without aortic dilation captured by high-performance image-based computational fluid dynamics

Wall shear stress calculations based on 3D cine phase contrast MRI and computational fluid dynamics: a comparison study in healthy carotid arteries

Correlation between wall shear stress and the rupture of saccular intracranial aneurysms:the initial experimental results with patient-specific 3-D computational model

Hemodynamic influence of mild stenosis morphology in different coronary arteries: a computational fluid dynamic modelling study

Computational analysis of patient-specific pulsatile blood flow: The influence of non-Newtonian models on wall shear stress assessment

Agreement of wall shear stress distribution between two core laboratories using three-dimensional quantitative coronary angiography

Numerical Simulation in the Abdominal Aorta and the Visceral Arteries with or Without Stenosis Based on 2D PCMRI

Longitudinal wall shear stress evaluation using centerline projection approach in the numerical simulations of the patient-based carotid artery

Wall shear stress and its role in atherosclerosis

[Flow Simulation of Normal Pulmonary Artery Branches Based on CT Image].

The effect of aneurismal-wall mechanical properties on patient-specific hemodynamic simulations: two clinical case reports