Abstract:It is known that new power transmission line inspection techniques have been developed over the last few years with great potential to improve and, in some cases, even replace traditional inspection procedures such as using helicopters and cars. A series of Unmanned Aerial Vehicles (UAVs) such as fixed-wing or rotary-wing UAVs, and vehicles that climb on the power transmission line, promise to revolutionize the inspection market. In this light, at least 39 new research studies and/or products have been conducted and/or introduced to the market, respectively. However, in an incipient way, some works point to the fusion of some technologies: the development of multi-rotor UAVs and the ability to connect and move over the power transmission line. In line with this, the current work was proposed, with significant unprecedented advances (such as an over-actuated control capacity with tilt rotors, the capability of a displacement in the angle, and the maintenance of active motors on the power transmission line), and the design, modeling, and control of an over-actuated UAV able to move over the conductor cable without the need for a new locomotion system is presented. The aircraft allows for a greater response and the indispensable ability to approximate landing in a power transmission line arbitrary position rather than the catenary lowest point (due to its ability to forward/backward move using the tilting rotors). Its design is detailed, its subsystems are described, and its normal and coupled flight mode dynamics are modeled. The results show good stability and reliable maneuvers for the coupling-to-power-transmission-line flight mode, without any overshoots, and the ability to follow the entire catenary through different Real Control Action (RCA) sets.

Cable-driven legged landing gear for unmanned helicopter: Prototype design, optimization and performance assessment

Design and Experimental Validation of an Adaptive Landing Gear for Safe Landing on Uneven Grounds of VTOL UAVs in the Context of Lightweight and Fast Adaptations

Enabling landings on irregular surfaces for unmanned aerial vehicles via a novel robotic landing gear

A Bird-Inspired Perching Landing Gear System1

A method for comprehensive performance optimization of four-leg landing gear based on the virtual equivalent parallel mechanism

Biomimetic Design for Unmanned Aerial Vehicle Safe Landing in Hazardous Terrain

MorphoGear: An UAV with Multi-Limb Morphogenetic Gear for Rough-Terrain Locomotion

A Novel Terrain Adaptive Landing Gear Robot

Research on Anti-Rollover Adaptive Landing Gear Technology Based on Impedance Control

A Novel Impedance-Based Parallel Cooperative Control Method for Front and Rear Landing Gear Hydraulic Systems of UAVs

Vertical Modeling and Autonomous Landing of a Mini Unmanned Helicopter

An Approach for Modeling and Performance Analysis of Three-Leg Landing Gear Mechanisms Based on the Virtual Equivalent Parallel Mechanism

Design of an Over-Actuated Hexacopter Tilt-Rotor for Landing and Coupling in Power Transmission Lines

Automated Design Optimization of a Mono Tiltrotor in Hovering and Cruising States

Control System for Vertical Take-Off and Landing Vehicle's Adaptive Landing Based on Multi-Sensor Data Fusion

Bionic Lightweight Design of Limb Leg Units for Hydraulic Quadruped Robots by Additive Manufacturing and Topology Optimization

Control System Design and Flight Testing for a Miniature Unmanned Helicopter

Design, structure analysis and shock control of aircraft landing gear system with MR damper

Ground effect modeling for small-scale unmanned helicopter

Perching and resting-A paradigm for UAV maneuvering with modularized landing gears

Design and dynamic analysis of landing gear system in vertical takeoff and vertical landing reusable launch vehicle