Selective Visible-Light Photocatalytic Oxidation of Sulfides and Catalytic CO 2 Fixation by Two-Interpenetrated Photoresponsive MOF-150

Yan Li,Fei Gao,Juanjuan Xue,Guo-Ping Yang,Yao-Yu Wang
DOI: https://doi.org/10.1021/acs.cgd.3c00120
IF: 4.01
2023-03-22
Crystal Growth & Design
Abstract:Sulfides and CO2 are the main pollutants that cause environmental acidification and the greenhouse effect. However, the rational use of these pollutants can not only save resources but also improve the environment. The two-interpenetrated MOF-150 was prepared by the photoresponsive 4,4′,4″-nitrilotribenzoic acid (H3NTB) ligand and Zn4O clusters, and it exhibits excellent optical activity derived from H3NTB. Especially as the substrate, thioanisole is oxidized to sulfoxide with medicinal value after 10 h of Xe light irradiation, and the conversion rate of 98% and the selectivity of 100% are obtained. Higher photocatalytic performance is also observed when the substrate is extended to other sulfides (7 examples). At the same time, MOF-150 has an excellent performance in the capture and recycling catalytic fixation of CO2. With epichlorohydrin as the reaction substrate, the cycloaddition efficiency of CO2 can reach over 99%. When it is extended to other epoxides, satisfactory cycloaddition efficiency was also obtained (7 examples). Therefore, MOF-150 is a promising heterogeneous catalyst with high catalytic efficiency and selectivity for a wide range of substrates.
chemistry, multidisciplinary,materials science,crystallography
What problem does this paper attempt to address?