Flexural Cracking Behavior of Steel-Nc-uhpc Composite Beam under Negative Bending Moment
Minghong Qiu,Junhui Cao,Zongxuan Shao,Huihui Li,Zhihao Qu,Cong Zhou,Xudong Shao
DOI: https://doi.org/10.1016/j.engstruct.2024.119071
IF: 5.582
2025-01-01
Engineering Structures
Abstract:Steel-concrete structures are widely applied in bridge engineering due to their superior mechanical performance and cost-effectiveness. However, normal concrete (NC) decks often suffer cracking problems, adversely affecting their serviceability. Ultra-high performance concrete (UHPC) can be used to partially replace the top of NC decks to enhance their post-cracking behavior because UHPC shows high tensile strength, strain-hardening characteristics in tension, and strong bond strength with NC. To this end, this paper focused on the flexural behavior of steel-NC-UHPC composite beams regarding their failure mode, stiffness, strain development, cracking behavior, crack width, etc. Test results indicated that the test specimens mainly exhibited two types of failure modes: shear failure of the NC layer and local buckling of the compressive flange at the steel girder, which were mainly determined by the reinforcement ratio. Flexural stiffness was controlled by the steel girder, and the reinforcement ratio had a notable effect on the reinforcement strain and crack propagation. Additionally, cracks can be categorized into three types: through cracks, connecting cracks, and separate cracks. These cracks in the UHPC layer and NC layer would affect each other, especially those near the roughening interface. The sectional nonlinear analysis was employed to calculate the strain of reinforcement and the steel girder accurately. Finally, the prediction methods of crack width for the NC layer and UHPC layer were discussed. Formulas in NF P18-710 were verified to be feasible for the prediction of UHPC crack width. The UHPC influence factor was introduced to modify the calculation results of the NC crack width by the Chinese NC code.