Abstract:In this study, three cationic surfactants (hexadecyltrimethylammonium chloride, hexadecyldimethylbenzylammonium chloride, and octadecyltrimethylammonium chloride) were used to modify montmorillonite and polyethylene (PE)/maleic anhydride grafted polyethylene (PE-g-MAH)/organic-montmorillonite (Org-MMT) nano-composites, prepared by two blending processes (direct-melt blending and solution blending). X-ray diffractometry and transmission electron microscopy were used to investigate the intercalation behavior and microstructure of composites. Mechanical properties were also tested. It was found that the intercalation effect of PE/PE-g-MAH/Org-MMT could be enhanced by increasing the content of PE-g-MMT, using the silicate modified by a cationic surfactant with a benzyl group or long alkyl chain, adopting the solution-blending method or using high-density polyethylene as matrix. The degree of crystallinity of composites and the crystalline thickness perpendicular to the crystalline plane [like (110) and (200)] decreased with increasing amounts of PE-g-MAH and, under certain prescription, the crystalline thickness of the composite made by the solution method was much smaller than that made by direct-melt blending. This clearly showed that Org-MMT and PE-g-MAH had a heterogeneous nucleation effect on crystallization of PE from the melt, resulting in a decrease of crystalline thickness, and the heterogeneous nucleation effect was more evident in the nanocomposite made by the solution-blending method than in that made by the direct-melt intercalation process. The tensile strength initially increased and then decreased with increasing contents of PE-g-MAH. The maximum value in tensile strength (23.3 MPa) was achieved when the concentration of PE-g-MAH was 6 wt %. The impact strength increased concomitantly with the content of PE-g-MAH; it was 122.2 J/m when the concentration of PE-g-MAH was 9 wt %. (C) 2004 Wiley Periodicals, Inc.

Mechanical, flame-retarding, and creep-recovery proprieties of ethylene-propylene-diene monomer enhanced with nano-hydroxide for undersea tunnel sealing gasket

Effect of graphene nanosheets and layered double hydroxides on the flame retardancy and thermal degradation of epoxy resin

Study on the Effect of Halloysite Nanotubes on the Mechanical Properties and Swelling Resistance of Ethylene-Propylene Diene Monomer (EPDM)/Nitrile Butadiene Rubber (NBR) Blend Nanocomposites

Preparation of nanoalumina/EPDM composites with good performance in thermal conductivity and mechanical properties

Preparation and Mechanical Properties Analysis of Rare Earth Filling Ethylene‐Allene Monomer Rubber Composite

Polyethylene/maleic Anhydride Grafted Polyethylene/organic‐montmorillonite Nanocomposites. I. Preparation, Microstructure, and Mechanical Properties

Experimental Evaluation of Aging Characteristics of EPDM As a Sealant for Undersea Shield Tunnels

The effect of α and γ phase nano Al2O3 on mechanical properties of ethylene-propylene-diene monomer using in high voltage cable accessories

The effect of /spl alpha/ and /spl gamma/ nano Al/sub 2/O/sub 3/ on mechanical properties of ethylene-propylene-diene monomer using in high voltage cable accessories

Anti‐migration performance of EPDM composite improved by octadecylamine‐functionalized graphene oxide

The Dynamic Mechanical Properties of EPDM/Al(OH)3 Composites

STUDY OF THE DYNAMIC MECHANICAL PROPERTIES OF EPDM／Al(OH)3 COMPOSITES

The Effect Of Alpha And Gamma Phase Nano Al2o3 On Mechanical Properties Of Ethylene-Propylene-Diene Monomer Using In High Voltage Cable Accessories

Preparation and Properties of Ethylene–propylene–diene Rubber/organomontmorillonite Nanocomposites

Mechanically robust and flame-retarded EPDM composites with high loading of Mg(OH)2 based on reversible crosslinking network from Diels-Alder reactions

Preparation and Properties of Semi-Transparent EPDM/Montmorillonite Nanocomposites

A thermally reversible healing EPDM based elastomer with higher tensile properties and damping properties

Effect of complex of resorcinol and hexamethylenetetramine modified halloysite nanotubes (RH-HNTs) on the mechanical and swelling characteristics of NR/EPDM nanocomposites

Effect of Micro-Nano Additives on Breakdown, Surface Tracking and Mechanical Performance of Ethylene Propylene Diene Monomer for High Voltage Insulation

Effect of HNTs and Modified HNTs Nanotubes on the Mechanical Properties and Swelling Resistance of EPDM/SBR Rubber Blend Nanocomposites

Influence of Clay Modification on the Structure and Mechanical Properties of Epdm/Montmorillonite Nanocomposites