Film cooling enhancement over oblong-dimpled cutback surfaces for the trailing edge of turbine blades
Yuan Li,Yu Rao,Yuyang Liu,Alexandros Terzis
DOI: https://doi.org/10.1016/j.ijheatfluidflow.2024.109450
IF: 2.643
2024-06-15
International Journal of Heat and Fluid Flow
Abstract:This study investigates the correspondence between film cooling flow and convective heat transfer augmentation on the trailing edge cutback surface of a turbine blade, proposing a novel approach with oblong dimples in V-pattern pairs to enhance the cooling performance. Using transient infrared thermography coupled with the Impulse Response Method, detailed measurements of adiabatic film cooling effectiveness and heat transfer coefficients were obtained. Scale-Adaptive-Simulations (SAS) were also utilized to delve into the turbulent flow dynamics and elucidate the mechanisms behind the enhanced cooling performance. The experiments and simulations were conducted for a trailing edge model equipped with pin fin arrays inside the coolant channel and a land feature on the cutback surface. Overall, three different cutback surfaces were investigated: a smooth baseline geometry and two dimpled surfaces with different geometrical orientation. The cooling performance was evaluated over a range of blowing ratios spanning between 0.5 and 2. The results indicate that as the blowing ratio increases, there is a corresponding enhancement in both the adiabatic film cooling effectiveness and the heat transfer coefficients across all three cutback surface configurations. However, the dimpled patterns, when compared to the smooth one, showed a broader coolant film distribution and facilitated the formation of small-scale vortices, which in turn improved the heat transfer efficiency. Specifically, surfaces with a tighter arrangement of dimples exhibited superior cooling effects, achieving approximately 5.0 % increase in the film cooling effectiveness and an 8.9 % boost in the convective heat transfer coefficients. Moreover, the strategic placement of V-pattern dimples effectively steers the coolant flow close to the wall towards the land, significantly enhancing coolant spread and thus offering improved thermal protection for the land area. These findings hold the potential to significantly improve the performance of aero-engines by optimizing the trade-off between thermal management and aerodynamic efficiency of turbine blades.
engineering, mechanical,thermodynamics,mechanics