Development of novel heteroatoms enriched nanoporous material for rapid removal of Pb(II) ions from water bodies by batch adsorption and cross-flow membrane filtration method

Jasasmita Das,Anuj Rawat,Monika Chaudhary,Abhijit Maiti,Paritosh Mohanty
DOI: https://doi.org/10.1016/j.jwpe.2024.104823
IF: 7
2024-01-24
Journal of Water Process Engineering
Abstract:N and P-enriched nanoporous material (NPNM), synthesized within 30 min by microwave-assisted method, is used to remove Pb(II) ion from aqueous solution rapidly. A specific surface area (SA BET ) of 450 m 2 g −1 with pore size 1.1, 3.2 nm and pore volume of 0.34 cm 3 g −1 has been estimated. In the batch adsorption process , rapid removal of Pb(II) ion was observed within 15 min, and the final concentration reached below the permissible limit (by WHO) of drinking water <10 ppb, when 1.6 ppm of initial concentration was used. The maximum adsorption capacity of 750 mg g −1 was estimated for 600 ppm of initial Pb(II) concentration. The adsorption isotherm fitted well with the Langmuir nonlinear isotherm model, and kinetic parameters indicate the better fitting of the pseudo-first order nonlinear model. Thermodynamic parameters, such as ΔH (−25.7 kJ mol −1 ) and ΔG (−16.6 kJ mol −1 ) indicate the exothermic and spontaneous nature of the adsorption process, respectively. Additionally, a mixed matrix membrane (MMM) developed by NPNM successfully treated 5 L of 1.6 ppm Pb(II) ion solution, producing safe drinking water for 7 h with 10.1 L m −2 h −1 flux at a transmembrane pressure of 2 bar. Moreover, the membrane's (MMM) recyclability investigations have been carried out successfully for up to three consecutive cycles. The adsorption mechanism was studied by the spectroscopic analysis (FT-IR, XPS, EDAX mapping), which revealed the key role of N in the adsorption process.
engineering, chemical, environmental,water resources
What problem does this paper attempt to address?