Abstract:By photodeposition of CrOx on SrTiO3-based semiconductors doped with aliovalent Mg(II) and functionalized with Ni/NiOx catalytic nanoparticles (economically significantly more viable than commonly used Rh catalysts), an increase in apparent quantum yield (AQYs) from ∼10 to 26% in overall water splitting was obtained. More importantly, deposition of CrOx also significantly enhances the stability of Ni/NiO nanoparticles in the production of hydrogen, allowing sustained operation, even in intermittent cycles of illumination. In situ elemental analysis of the water constituents during or after photocatalysis by inductively coupled plasma mass spectrometry/optical emission spectrometry shows that after CrOx deposition, dissolution of Ni ions from Ni/NiOx-Mg:SrTiO3 is significantly suppressed, in agreement with the stabilizing effect observed, when both Mg dopant and CrOx are present. State-of-the-art electron microscopy and energy-dispersive X-ray spectroscopy (EDX) and electron energy-loss spectroscopy (EELS) analyses demonstrate that upon preparation, CrOx is photodeposited in the vicinity of several, but not all, Ni/NiOx particles. This implies the formation of a Ni–Cr mixed metal oxide, which is highly effective in water reduction. Inhomogeneities in the interfacial contact, evident from differences in contact angles between Ni/NiOx particles and the Mg:SrTiO3 semiconductor, likely affect the probability of reduction of Cr(VI) species during synthesis by photodeposition, explaining the observed inhomogeneity in the spatial CrOx distribution. Furthermore, by comparison with undoped SrTiO3, Mg-doping appears essential to provide such favorable interfacial contact and to establish the beneficial effect of CrOx. This study suggests that the performance of semiconductors can be significantly improved if inhomogeneities in interfacial contact between semiconductors and highly effective catalytic nanoparticles can be resolved by (surface) doping and improved synthesis protocols.This article has not yet been cited by other publications.

Visible-light Deposition of CrOx Cocatalyst on TiO2: Cr Valence Regulation for Superior Photocatalytic CO2 Reduction to CH4

Visible-light deposition of CrO cocatalyst on TiO2: Cr valence regulation for superior photocatalytic CO2 reduction to CH4

Independent Cr2O3 functions as efficient cocatalyst on the crystal facets engineered TiO2 for photocatalytic CO2 reduction

Photothermal Catalysis for Selective CO2 Reduction on the Modified Anatase TiO2 (101) Surface

CrO x -Mediated Performance Enhancement of Ni/NiO-Mg:SrTiO 3 in Photocatalytic Water Splitting

Unraveling Active Sites Regulation and Temperature-Dependent Thermodynamic Mechanism in Photothermocatalytic CO2 Conversion with H2O

Self-assembly of a Highly Stable and Active Co3O4/H-TiO2 Bulk Heterojunction with High-Energy Interfacial Structures for Low Temperature CO Catalytic Oxidation

Tailoring the oxidation state of metallic TiO through Ti3+/Ti2+ regulation for photocatalytic conversion of CO2 to C2H6

Selectively Triggering Photoelectrons for CO2 to CH4 Reduction over SrTiO3 {110} Facet with Dual-Metal Sites

Visible-Light Driven CO2 Reduction to CO by Co3O4 Supported on Tungsten Oxide

Nitrogen-stabilized oxygen vacancies in TiO2 for site-selective loading of Pt and CoOx cocatalysts toward enhanced photoreduction of CO2 to CH4

Controllable Al2O3 Coating Makes TiO2 Photocatalysts Active under Visible Light by Pulsed Chemical Vapor Deposition

Strong Electronic Interaction Enables Enhanced Solar-Driven CO2 Reduction into Selective CH4 on SrTiO3 with Photodeposited Pt2+ Sites.

Electronic regulation of single-atomic Ti sites on metal hydroxide for boosting photocatalytic CO2 reduction

Selectively triggering photoelectrons for CO<sub>2</sub> to CH<sub>4</sub> reduction over SrTiO<sub>3</sub> {110} facet with dual-metal sites

Unveiling Atomic‐Scale Product Selectivity at the Cocatalyst‐TiO2 Interface Using X‐Ray Techniques: Insights into Interface Reactivity

Synergetic modulation of surface alkali and oxygen vacancy over SrTiO 3 for the CO 2 photodissociation

Single-Atom Fe Triggers Superb CO 2 Photoreduction on a Bismuth-Rich Catalyst

Advantageous Role of Ir0 Supported on TiO2 Nanosheets in Photocatalytic CO2 Reduction to CH4: Fast Electron Transfer and Rich Surface Hydroxyl Groups.

Enhanced Photocatalytic Reduction of CO2 on Rutile TiO2/MgAl Layered Double Oxides with H2O Under Ambient Temperature

CO2 dissociation activated through electron attachment on reduced rutile TiO2(110)-1x1 surface