Abstract:The late-injection strategy can decrease peak pressure rise rate (PRR) in reactivity controlled compression ignition (RCCI) and enables RCCI operation to high engine load. However, excessive soot emission is a limiting factor in this high engine load extension. Recently, polyoxymethylene dimethyl ethers (PODE) emerges as a promising direct-injection fuel for RCCI load extension due to the properties of high reactivity and high oxygen content. The late-injection RCCI strategy features a two-stage high-temperature heat release (HTHR) that has not been well understood. In this study, we investigated the effects of direct-injection fuel properties types and proportion on late-injection RCCI strategy on a light-duty optical engine using multiple optical diagnostic techniques. Iso-octane served as the premixed fuel and the in-cylinder direct-injection timing was set at the crank angle of −10° after the top dead center. Firstly, the combustion characteristics of RCCI with direct-injection fuels of n-heptane, PODE and cetane were compared. The NFL images prove that the PODE case shows less tendency of soot formation. The OH planar laser-induced fluorescence (PLIF) imaging indicates that the OH radical is widely distributed in the combustion chamber after the HTHR including the central part of the combustion chamber near the injector nozzle for all three cases. Secondly, the effects of direct-injection fuel proportion on the combustion characteristics of the late-injection RCCI strategy was evaluated using PODE as the direct-injection fuel. The NFL images show that the combustion regime in the low reactivity region of RCCI tends to change from auto-ignition to flame front propagation with the decreasing of the direct-injection fuel proportion from 30% to 6%. The introduction of the flame front propagation in the second-stage HTHR reduces the peak pressure rise rate of RCCI. We conclude that the peak PRR of RCCI at high engine load can be controlled by modulating the ratio between the auto-ignition and flame front propagation through tuning the proportion of the high-reactivity fuel in the direct injection.

A Comparative Study on the Performance of Partially Premixed Combustion (PPC), Reactivity-Controlled Compression Ignition (RCCI), and RCCI with Reverse Reactivity Stratification (R-RCCI) Fueled with Gasoline and Polyoxymethylene Dimethyl Ethers (Poden)

Potential of the Reverse-Reactivity Controlled Compression Ignition (R-RCCI) Combustion for Maintaining Ultra-Low Emissions and Enhanced Thermal Efficiency

Insight into the Combustion and Emission Performance of Reactivity-Controlled Compression Ignition (RCCI) Fueled with Hydrogen (H2) and Polyoxymethylene Dimethyl Ethers (Poden)

Experimental Study of RCCI Combustion and Load Extension in a Compression Ignition Engine Fueled with Gasoline and PODE

A Comparative Study on Partially Premixed Combustion (PPC) and Reactivity Controlled Compression Ignition (RCCI) in an Optical Engine

Control of low-temperature polyoxymethylene dimethyl ethers (PODEn)/gasoline combustion considering fuel concentration, fuel reactivity, and intake temperature at low loads

Experimental study on the high load extension of PODE/methanol RCCI combustion mode with optimized injection strategy

Effects of Direct-Injection Fuel Types and Proportion on Late-Injection Reactivity Controlled Compression Ignition

Control of low-temperature polyoxymethylene dimethyl ethers (PODE<sub>n</sub>)/ gasoline combustion considering fuel concentration, fuel reactivity, and intake temperature at low loads

An Efficient Data-Driven Approach for Modeling and Optimization of Reactivity-Controlled Compression Ignition Engine Fueled with Polyoxymethylene Dimethyl Ethers and Hydrogen

Investigations on reactivity controlled compression ignition combustion with different injection strategies using alternative fuels produced from waste resources

Experimental studies on combustion and emissions of RCCI (reactivity controlled compression ignition) with gasoline/n-heptane and ethanol/n-heptane as fuels

A Comprehensive Study of Fuel Reactivity on Reactivity Controlled Compression Ignition Engine: Based on Gasoline and Diesel Surrogates

Numerical Investigation on the Combustion Characteristics of PODE3/gasoline RCCI and High Load Extension

Combined Effects of Fuel Reactivity, Φ-Sensitivity, and Intake Temperature on the Performance of Low-Temperature Gasoline/polyoxymethylene Dimethyl Ethers Combustion

Numerical Study Of Rcci And Hcci Combustion Processes Using Gasoline, Diesel, Iso-Butanol And Dtbp Cetane Improver

Effect of Fuel Injection Pressure and Premixed Ratio on Mineral Diesel-Methanol Fueled Reactivity Controlled Compression Ignition Mode Combustion Engine

Comprehensive Analysis of Combustion Behaviors of Hydrogen (h2)/diesel Reactivity-Controlled Compression Ignition (RCCI) in a Light-Duty Diesel Engine

A Parametric Study for Enabling Reactivity Controlled Compression Ignition (RCCI) Operation in Diesel Engines at Various Engine Loads

Experimental Study On High-Load Extension Of Gasoline/Pode Dual-Fuel Rcci Operation Using Late Intake Valve Closing

Experimental Study on Combustion Characteristics of a Fischer‐tropsch Diesel/methanol Reactivity Controlled Compression Ignition Mode Engine