Anisotropic Performance of High-Quality MAPbBr 3 Single-Crystal Wafers
Leilei Zhang,Shuangyue Cui,Qing Guo,Chao Ge,Quanxiang Han,Qinglian Lin,Cuicui Li,Xiaoxin Zheng,Zhongjun Zhai,Lei Wang,Qihao Sun,Yadong Xu,Yang Liu,Xutang Tao
DOI: https://doi.org/10.1021/acsami.0c14582
2020-11-09
Abstract:It has been proved that bulk single crystals of a halide perovskite behave much better than its polycrystalline counterparts in multiple application scenarios. Thus, the growth of large-sized and high-quality single crystals is significant to guarantee their ultimate device performances. Here, based on our recently invented settled temperature and controlled antisolvent diffusion system, improvements achieved in this work include the following: (1) We modified the growth system to optimize the control over both mass and heat transport to alleviate defect formation. State-of-the-art-quality MAPbBr<sub>3</sub> crystals were grown, and from the bulk crystals, differently oriented crystalline wafers were fabricated with the full width at half-maximum of X-ray rocking curves of 40–86 arcsec. (2) The optical band gaps revealed no anisotropy on differently oriented wafers, whereas the refractive index and extinction coefficient exhibited obvious anisotropy. (3) Angle-resolved polarized Raman spectra demonstrate distinct in-plane anisotropy on (100) and (110) wafers but not on the (111) wafer. The equilibrium MA<sup>+</sup> orientations are deduced to adopt the <111> direction with the antiparallel MA<sup>+</sup> orientation between adjacent domains. (4) Radiation detectors fabricated on differently oriented wafers proved photoresponse anisotropy to both visible and X-ray radiation, following a general order of (100) > (110) > (111). Because anisotropy is an inevitable issue for various applications employing crystalline materials, this study, based on the clarification of the debatable intrinsic dipole configuration in the pseudocubic crystal lattice, will provide quantitative information on physicochemical property anisotropy and subsequently facilitate optimization of device performance referring to crystal orientations of halide perovskite crystals.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c14582?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c14582</a>.Density and ultraviolet photoelectron spectroscopy (UPS) measurements of an MAPbBr<sub>3</sub> crystal; PL lifetime measurements and Raman spectra of (100), (110), and (111) oriented MAPbBr<sub>3</sub> single-crystal wafers; angular resolved polarization Raman spectroscopy and polar plots of the vibration intensity of differently oriented MAPbBr<sub>3</sub> wafers; light excitation measurement setup and current–voltage (<i>I</i>–<i>V</i>) curves for (100), (110), and (111) wafers; photocurrent and detectivity (<i>D</i>*) and on–off switching of photocurrents on the (100), (110), and (111) wafer devices; comparison of bulk single-crystal growth of organic–inorganic halide perovskites; comparison of visible light and X-ray radiation detections based on organic–inorganic halide perovskite bulk single crystals (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c14582/suppl_file/am0c14582_si_001.pdf">PDF</a>)Seed crystals with poor quality turning into polycrystals during the recovery period (Video S1) (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c14582/suppl_file/am0c14582_si_002.mp4">MP4</a>)Video showing fluctuations of temperature and antisolvent content producing a large number of small crystals at the bottom of the crystallizer (Video S2) (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c14582/suppl_file/am0c14582_si_003.mp4">MP4</a>)Actual situation of crystal growth (Video S3) (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c14582/suppl_file/am0c14582_si_004.mp4">MP4</a>)This article has not yet been cited by other publications.
materials science, multidisciplinary,nanoscience & nanotechnology