Abstract:Concrete-filled multicellular steel tube (CF-MCST) wall is widely used in China in recent years. In the companion paper, the moment capacity of the connection joining an I-beam to a CF-MCST wall was studied. Realizing that the insight into the connection's stiffness would greatly benefit performing a fine structural analysis, this paper aims to propose a theoretical approach for approximating the rotational stiffness of the connection. Finite Element (FE) model is first established for analysis, which is validated by using the experimental results extracted from previous studies. In order to attain the stiffness resulting from the endplate and the wall individually, an additional companion FE model is employed, where the endplate's deformation is negligible by using an extreme great value for the Young's modulus of the endplate and the connection's rotation is therefore mainly attributed to the wall's local deformation near the connection. For the stiffness accounting for the deformation of the endplate, the stiffness accounting for the local deformation of the wall, and the connection's stiffness, parametric study is then performed via the validated FE models whose geometrical parameters falling into the range conventionally taken in the engineering. Based on the FE analysis results, the abstracted mechanical model is proposed, resulting in semi-empirical formulas where partial parameters are identified by the means of regression analysis. It is found that enlarging the geometrical parameters would improve the connection's stiffness. Among the parameters, the beam height has the most significant effects on the connection's stiffness. Accordingly, increasing the beam height first is suggested for the aim of enhancing the connection's stiffness. The comparison of the results obtained via the FE analyses and that obtained via the proposed theoretical approach shows a good agreement, and the error is <10% regarding the connection's stiffness.

Study on the Moment Capacity of a Connection Joining an I-beam to Concrete-Filled Multicellular Steel Tube Walls

Experimental study on the steel tube moment connections with modified cover-plated reinforcement

Experimental study on reinforcing moment connections for square steel tubes in National Swimming Center

Experimental Study on Edge Cell Partially-Replaced Joint for I-beam to Multi-Celled CFST Walls under Cyclic Loading

Initial Stiffness of Connection Joining I-beam to Concrete-Filled Multicellular Steel Tube Wall

Seismic Behavior of Exterior Connections with Steel Beams Bolted to Cft Columns

Seismic Behavior of an Improved Drilled Flange Connection for I-beam to CFST Column

EXPERIMENTAL STUDY ON THE SEISMIC BEHAVIOR OF CFST RECTANGULAR COLUMN TO H-SECTION STEEL BEAM CONNECTIONS WITH EXTERNAL STIFFENERS

Experimental Study on Reduced I-beam to CFRST Column Joints under Cyclic Loading

Experimental Study On Seismic Behavior Of Innovative Multi-Cellular Cft-Walls With Tie-Bolts

Behavior and design of steel beam to multi-celled corrugated-plate CFST wall joints

Experimental Investigation of Concrete-Filled Steel Tubular Longitudinal Gusset Plate Connections

02.05: Design of concrete-filled steel tubular longitudinal gusset plate connections

Design Of Concrete-Filled Steel Tubular Chs Connections In Tension

Stability Design of Multi-Celled Corrugated-Plate CFST Walls under Combined Axial and In-Plane Bending Loads

Stability behavior of multi-celled corrugated-plate concrete filled steel tubular walls

Experimental Study on Tensile Fracture Mechanism of Butt Joints in Multi-Celled CFST Walls

Global Buckling Design of Multi-Celled CFST Walls with Four Simply-Supported Edges

Global Stability Tests and Design of Multi-Celled Concrete-Filled Steel Tubular Walls

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Mechanism of Load Introduction and Transfer Within Steel-Encased CFST Members with Shear Connections