Abstract:Flapping flight has undoubtedly played a significant role in many of the aeronautical engineering achievements in the past several centuries. Flapping motions of wings/fins are used by animals (such as birds, insects and bats) to generate lift or thrust to keep them aloft in the surrounding fluid. Researches in this area are not only motivated by the fundamental interest of understanding the mechanism of flapping flight, but also the development of Micro Air Vehicles (MAVs) based on biomimetics. In this lecture, we will address our efforts towards both experimental studies and virtual testing of flapping flight with our High End Digital Prototyping (HEDP) system. The aim of our research is to use physical and biological models to drive the engineering design of these vehicles. Firstly, two types of flapping-wing Unmanned Air Vehicles (UAVs) with spatial four-bar drive mechanism will be presented, including the wind tunnel experiment and prototype flight test results. Secondly, various computation approaches have been adopted to simulate the flapping motions, including traditional moving mesh techniques based on Arbitrary Lagrangian Eulerian (ALE) formulation, and Lattice Boltzmann method with immersed boundary methods. For a single wing-system, we have investigated the influences of various parameters on both the symmetric flapping and asymmetric flapping with bird-like or turtle-like flapping mode. For a tandem wing system, we have investigated the interaction between the hind wing and the vortex shedding off the fore wing and learned how to utilize the flow mechanism to achieve better aerodynamic performances. Moreover, Dynamic Mode Decomposition (DMD) algorithm has been adopted to reveal the underlying physics due to its capability and accuracy in analyzing the complex transient systems. Finally, the flight control design of a dragonfly-like Flapping Wing Micro Aerial Vehicle (FWMAV) is presented, which has incorporated a Linear-Quadratic Regulator (LQR) method and an Iterative Learning Tuning (ILT). In general, we expect that these virtual testing by computational simulations and flight control can drive the design of our next generation flapping-wing UAVs in the future.

Flight Control of a Large-Scale Flapping-Wing Flying Robotic Bird: System Development and Flight Experiment

Trajectory Generation and Tracking Control for Flapping Wing Robot Three-Dimensional Flight

Toward Practical Autonomous Flight Simulation for Flapping Wing Biomimetic Robots with Experimental Validation

Autonomous Formation Flight Control of Large-Sized Flapping-Wing Flying Robots Based on Leader–Follower Strategy

Towards Virtual Testing of Flapping Flight

A Kind of Large-Sized Flapping Wing Robotic Bird: Design and Experiments

Adaptive Sliding Mode Control with Transition Process for Flapping Wing Aerial Vehicle

Autonomous Flight Control with Different Strategies Applied During the Complete Flight Cycle for Flapping-Wing Flying Robots

An All Servo-Driven Bird-Like Flapping-Wing Aerial Robot Capable of Autonomous Flight

Target Detection and Localization for Flapping-Wing Robots Based on Biological Eagle-Eye Vision

An at-scale tailless flapping wing hummingbird robot: II. Flight control in hovering and trajectory tracking

Development of Vision Stabilizing System for a Large-Scale Flapping-Wing Robotic Bird

Design and Control of a Small Intelligent Camera Stabilizer for a Flapping-Wing Robotic Bird

The Embedded On-Board Controller and Ground Monitoring System of a Flapping-Wing Aerial Vehicle.

Design Optimization and System Integration of Robotic Hummingbird

Development of an Autonomous Flapping-Wing Aerial Vehicle.

Flappy Hummingbird: an Open Source Dynamic Simulation of Flapping Wing Robots and Animals.

Adaptive control of a millimeter-scale flapping-wing robot

Geometric Flight Control of a Hovering Robotic Hummingbird.

Flying State Sensing and Estimation Method of Large-Scale Bionic Flapping Wing Flying Robot

HIT-Hawk and HIT-Phoenix: Two Kinds of Flapping-Wing Flying Robotic Birds with Wingspans Beyond 2 Meters