Abstract:Currently, relatively large errors are found in numerical results in some low-specific-speed centrifugal pumps with unshrouded impeller because the effect of clearances and holes are not accurately modeled. Establishing an accurate analytical model to improve performance prediction accuracy is therefore necessary. In this paper, a three-dimensional numerical simulation is conducted to predict the performance of a low-specific-speed centrifugal pump, and the modeling, numerical scheme, and turbulent selection methods are discussed. The pump performance is tested in a model pump test bench, and flow rate, head, power and efficiency of the pump are obtained. The effect of taking into consideration the back-out vane passage, clearance, and balance holes is analyzed by comparing it with experimental results, and the performance prediction methods are validated by experiments. The analysis results show that the pump performance can be accurately predicted by the improved method. Ignoring the back-out vane passage in the calculation model of unshrouded impeller is found to generate better numerical results. Further, the calculation model with the clearances and balance holes can obviously enhance the numerical accuracy. The application of disconnect interface can reduce meshing difficulty but increase the calculation error at the off-design operating point at the same time. Compared with the standard k-ɛ, renormalization group k-ɛ, and Spalart-Allmars models, the Realizable k-ɛ model demonstrates the fastest convergent speed and the highest precision for the unshrouded impeller flow simulation. The proposed modeling and numerical simulation methods can improve the performance prediction accuracy of the low-specific-speed centrifugal pumps, and the modeling method is especially suitable for the centrifugal pump with unshrouded impeller.

A Flow Information-Based Prediction Model Applied to the Nonaxisymmetric Hub Optimization of a Centrifugal Impeller

Performance Prediction of Centrifugal Pump Based on the Method of Numerical Simulation

Whole flow field performance prediction by impeller parameters of centrifugal pumps using support vector regression

Effect of Relative Positions between Blade and Volute Tongue on Prediction of Performance in Simulation of Centrifugal Pump

Artificial neural network for the performance improvement of a centrifugal pump

Numerical Simulation of Inner Flow Field in Centrifugal Impeller with Long, Middle and Short Blades

Numerical Simulation on Internal Flow in the Screw Centrifugal Pulp Pump

Numerical Simulation of Flow in Centrifugal Pump with Complex Impeller

CFD and Neural Network-Based Predicting for Oil Delivery Performance of Oil Pump in Engines

Optimization of a Centrifugal Pump to Improve Hydraulic Efficiency and Reduce Hydro-Induced Vibration

Impeller design criterion based on numerical simulation of stock pump flow field and its application

Two-Stage Hybrid Model for Efficiency Prediction of Centrifugal Pump

Rotating machinery flow field prediction based on hybrid neural network

A Surrogate Model for a CAES Radial Inflow Turbine with Test Data-Based MLP Neural Network Algorithm

Impeller optimization using a machine learning-based algorithm with dynamic sampling method and flow analysis for an axial flow pump

One-dimensional Modeling for Tip Clearance Leakage Vortex Trajectory and Stall-Onset Prediction in Subsonic Centrifugal Impellers

Prediction Method of Impeller Performance and Analysis of Loss Mechanism for Mixed-Flow Pump

Numerical Analysis of Unstable Turbulent Flows in a Centrifugal Pump Impeller Considering the Curvature and Rotation Effect

An axisymmetric characteristic model for enhancing the prediction of centrifugal compressor characteristics

Investigation of CFD Calculation Method of a Centrifugal Pump with Unshrouded Impeller

Optimization of Hydraulic Efficiency and Internal Flow Characteristics of a Multi-Stage Pump Using RBF Neural Network