Abstract:Wide-viscosity-range impellers have extensive demands and applications in process industry. The gas–liquid dispersion and mass transfer characteristics of wide-viscosity-range impellers including Large-double-blade (LDB) impeller, Fullzone (FZ) impeller and Maxblend (MB) impeller in water solutions of xanthan gum were investigated experimentally and compared. The influences of gas flow rate, impeller speed and polymer concentration of liquid on the power consumption, overall gas holdup εg and mass transfer coefficient KLa were also analyzed. On this basis, the appropriate operating parameters and impeller type were determined. The results indicate that with rising flow rate, the higher εg and KLa can be achieved with a drop in power consumption, and a relatively high flow rate is recommended on the premise of guaranteeing the complete dispersal condition in aerated vessel. Higher impeller speed provides better gas–liquid dispersion and mass transfer performance, but results in more power consumption simultaneously. The appropriate impeller speed should be just enough to meet the requirements of εg and KLa. It also is found that the increasing concentration of water solution of xanthan gum adds to the complexity of gas dispersion and mass transfer in aerated vessel. Under the same specific power consumption PV, the εg and KLa are positive and negative correlation with the polymer concentration of liquid, respectively. Specially, when the concentration of water solution of xanthan gum is relatively low, the FZ impeller exhibits the best gas dispersion and mass transfer performance under the same specific power consumption. Nevertheless, the mass transfer performance of FZ impeller deteriorates significant when the concentration of water solution of xanthan gum increases to 1.00 wt%, and the MB impeller becomes the most appropriate impeller type in this condition.

Liquid–Liquid Dispersion and Selectivity of Chemical Reactions in the Inline Teethed High Shear Mixers

Hydrodynamics and mixing process in a horizontal self-cleaning opposite-rotating twin-shaft kneader

Study of Liquid-Liquid Extraction and Mass Transfer Process with Solid Particles in the Inline Teethed High Shear Mixer

Geometrical Improvement of Inline High Shear Mixers to Intensify Micromixing Performance

Nanoparticle Deagglomeration Driven by a High Shear Mixer and Intensification of Low-Speed Stirring in a Viscous System

Gas–Liquid Mass Transfer Characteristics in Two Inline High Shear Mixers

An experimental study of localized flow pattern, strain rate and turbulence kinetic energy dissipation rate of in-line teethed high shear mixer with different rotor and stator structures

Effects of Stator and Rotor Geometry on Inline High Shear Mixers: Residence Time Distribution, Flow, and Energy Consumption

The structure-effect relationship between inline high shear mixers and micromixing: Experiment and CFD simulation

Residence time distributions of in-line high shear mixers with ultrafine teeth

Investigation of Gas–liquid Dispersion and Mass Transfer Performance of Wide-Viscosity-range Impellers in Water Solutions of Xanthan Gum

Experimental Study on Micromixing Characteristics of Novel Large-Double-blade Impeller

Liquid–liquid Mass Transfer Property of Two Inline High Shear Mixers

High Shear Mixer Works As a Heat Exchanger Enhancing the Liquid–liquid Direct Contact Heat Transfer

Novel Rotor-Stator Assembly Promotes the Emulsification Performance in an Inline High-Shear Mixer

Cfd Analysis of Flow Pattern and Power Consumption for Viscous Fluids in In-Line High Shear Mixers

LDA Measurements and CFD Simulations of an In‐line High Shear Mixer with Ultrafine Teeth

Micromixing Performance of the Teethed High Shear Mixer under Semi-Batch Operation

CFD simulation on shear-thinning gas-liquid dispersion in coaxial mixer

Single-Pass Emulsification Processes in Two Different Inline High Shear Mixers

Micromixing Simulation of Novel Large-Double-Blade Impeller