Abstract:The treatment of nanoparticle (NP) polluted aqueous suspensions by flotation can be problematic due to the low probability of collision between particles and bubbles. To overcome this limitation, the present work focuses on developing an enhanced flotation technique using the surface-functionalized micro-bubbles - colloidal gas aphrons (CGAs). The CGA generator was adapted to be air flow rate controlled based on the classical Sebba system; thus it could be well adopted in a continuous flotation process. Cetyl trimethylammonium bromide (CTAB) and sodium dodecyl sulfate (SDS) were employed for CGA creation. Positively surface-charged CTAB-CGAs (similar to 44.1 mu m in size) and negatively surface-charged SDS-CGAs (similar to 42.1 mu m in size) were produced at the optimum stirring speed of 8000 rpm. The half-life of CGAs varied from 100 s to 340 s under the tested conditions, which was largely sufficient for transferring CGAs from bubble generator to flotation cell. The air flow led to less stable CTAB-CGAs but apparently enhanced the stability of SDS-CGAs at higher air flow rates. In the presence of air flow, the drainage behavior was not much related to the type of surfactants. The continuous CGA-flotation trials highlighted the effective separation of silica nanoparticles - the removal efficiencies of different types of SiO2 NPs could reach approximately 90%-99%; however, at equivalent surfactant concentrations, no greater than 58% of NPs were removed when surfactants and bubbles were separately added into the flotation cell. The SiO2 NPs with small size were removed more efficiently by the CGA-flotation process. For the flotation with CTAB-CGAs, the neutral and basic initial SNP suspension was recommended, whereas the SDS-CGAs remained high flotation efficiency over all investigated pH. The good performance of CGA-flotation might be interpreted: most of the surfactant molecules well covered/coated on the surfaces of stable CGAs and thus fully contacted with NPs, resulting in the efficient utilization of surfactants. (C) 2017 Elsevier Ltd. All rights reserved.

Recent Advances for Understanding the Role of Nanobubbles in Particles Flotation

Current status of research on nanobubbles in particle flotation

A review of bulk nanobubbles and their roles in flotation of fine particles

Effect of Bulk Nanobubbles on the Entrainment of Kaolinite Particles in Flotation

Effects of Pure and Modified Nanobubbles on the Reverse Flotation of Kaolinite from Hematite

Latest advances and progress in the microbubble flotation of fine minerals: Microbubble preparation, equipment, and applications

A review and perspective on micro and nanobubbles: What They Are and Why They Matter

Improving micro-fine mineral flotation via micro/nano technologies

Enhanced Kaolinite Flotation Using Amine Coated Nanobubbles

Surface-modified Microbubbles (colloidal Gas Aphrons) for Nanoparticle Removal in a Continuous Bubble Generation-Flotation Separation System.

Nanobubble-enhanced flotation of ultrafine molybdenite and the associated mechanism

Aggregates characterizations of the ultra-fine coal particles induced by nanobubbles

From Microbubbles to Nanobubbles: Effect on Flotation

Effects of nanobubbles in column flotation of Chinese sub-bituminous coal

The role of surface forces in mineral flotation

Effect of Nanobubbles on the Flotation Behavior of Microfine-Grained Serpentine

Hydrodynamics of froth flotation and its effects on fine and ultrafine mineral particle flotation: A literature review

Effects of micro- and nano-bubbles on the flotation separation of unburned carbon from coal fly ash

An experimental study on size distribution and zeta potential of bulk cavitation nanobubbles

Evaluation of the flotation efficiency of nano and micro bubbles tailored to optimize bubble size distribution using a kinetic model

An Investigation of Nanobubble Enhanced Flotation for Fly Ash Decarbonization