Abstract:It is essential to understand the in-situ geomechanical properties of natural gas hydrate-bearing reservoirs for hydrate drilling, the design of reservoir stimulation and production schemes, geologic disaster prevention, and environmental impact assessment. In this way, it serves as the basis for the development and utilization of gas hydrate resources. In 2016, the Guangzhou Marine Geological Survey conducted the fourth natural gas hydrate drilling (Expedition GMGS4) in the north of the South China Sea, during which the effective stress of gas hydrate-bearing reservoirs in the study area was ascertained and gas hydrate-bearing pressure cores were collected. The effective stress was determined to be 700–800 kPa by in-situ piezocone penetration tests. The saturation, permeability, and shear strength of gas hydrates in the pressure core samples were measured under the in-situ stress state using the shipboard multi-sensor core logger (MSCL), pressure core analysis and transfer system (PCATS), and PCATS Triaxial system. Based on this, the distribution characteristics and the relationship of the permeability and gas hydrate saturation of the gas hydrate-bearing reservoirs were explored. Furthermore, the effects of effective stress and gas hydrate saturation on shear strength of gas hydrate-bearing clayey-silt sediments were mainly analyzed, as well as the stress–strain characteristics of gas hydrate-bearing sediments. The results are as follows: (i) the gas hydrate saturation and reservoir permeability in the study area are 0.7%–55% and 10−3–10−1mD, respectively, indicating low-permeability reservoirs; (ii) the gas hydrate saturation and reservoir permeability have obvious anisotropy in horizontal and vertical directions; (iii) the undrained shear strength of gas hydrate-bearing sediments is 0.24–0.52 MPa, and the shear strength of fine-grained sediments is more sensitive to the changes of in-situ stress. In the case that deviatoric stress continues increasing, micro-fractures may occur inside gas hydrate-bearing sediments, and this can lead to drastic changes in the strength of gas hydrate-bearing reservoirs. Therefore, it is necessary to take into account the effects of micro-fractures in gas hydrate-bearing reservoirs on engineering safety during long-term hydrate production.

Triaxial Tests on Water-Saturated Gas Hydrate-Bearing Fine-Grained Samples of the South China Sea under Different Drainage Conditions

Undrained triaxial tests on water-saturated methane hydrate–bearing clayey-silty sediments of the South China Sea

Mechanical Behaviours of Gas-Hydrate-bearing Clayey Sediments of the South China Sea

Formation Kinetics and Morphology Characteristics of Fracture-Filling Natural Gas Hydrate under the Influence of Multiple Parameters

An Experimental Study from the South China Sea

Geomechanical properties of gas hydrate-bearing sediments in Shenhu Area of the South China Sea

Mechanical Behavior of Hydrate-Bearing Clayey-Silty Sediments in the South China Sea: Strain-Rate Dependency

Mechanical Properties and Strength Criterion of Clayey Sand Reservoirs During Natural Gas Hydrate Extraction

Undrained Mechanical Properties of Overlying Soils of Gas Hydrate Reservoirs in the South China Sea

Experimental Study On the Effect of Hydrate Filling On the Mechanical Properties of Marine Sediments in the Shenhu Area, South China Sea

BEHAVIOR OF PORE WATER PRESSURE IN DYNAMIC TRIAXIAL TESTS OF SATURATED SOFT CLAY AND ITS EFFECT ON EFFECTIVE STRESS PATH

Triaxial Testing Study Of Dilatant Characteristics Of Qiantangjiang Alluvial Unsaturated Silts

Effect of Initial Pore Pressure on Undrained Shear Behaviour of Fine-Grained Gassy Soil

Stress-dilatancy Behaviour of Bubbled Fine-Grained Sediments

Natural core-based laboratory analysis and comparisons of the mechanical and hydraulic characteristics of the soil skeleton of hydrate reservoirs in the South China Sea

Effect of clay type and content on the mechanical properties of clayey silt hydrate sediments

Strength and creep characteristics of methane hydrate-bearing clayey silts of the South China Sea

Numerical Investigation of the Deformation Characteristics of Hydrate-Bearing Sediments During Hydrate Extraction

DEM investigation of the effect of hydrate morphology on the mechanical properties of hydrate-bearing sands

Stress-strain response and deformation behavior of hydrate-bearing sands under different grain sizes: A particle-scale study using DEM

Numerical Simulation of Direct Shear Tests on Gas Hydrate-Bearing Sediments Using the Discrete Element Method