Abstract:In the last few years, broadband and switchable frequency selective surfaces (FSSs) absorber/reflector are of great importance in different areas such as stealth system, EM interference, EM compatibility, and so on. In this paper, to obtain a switchable frequency selective surfaces absorber/reflector in different states, a broadband and switchable absorber using an absorb/reflective FSS is presented. The top layer of the proposed switchable absorber is a periodic arrangement of square loops loaded with PIN diodes on a dielectric substrate which has a sufficient mechanical strength to hold up all the units, and under the square loops there are honeycomb of a certain thickness and a thin layer of metal. The structure has been characterized with the full-wave analysis and shows good absorption/reflection switching performance. Intrinsic impedance of proposed structure has also been investigated to explain the switching and the broadband absorption mechanisms of the structure. The working frequency band of the switchable absorbing structure is 2.5 ~ 5.5 GHz, and it switches states by changing the bias voltage. Biasing at different voltages to turn ON and OFF the diodes, the FSS structure can switch freely between absorption and reflection state. In ON state, the switchable FSS has two states working as a wideband absorber and the reflectivity in 2.5 ~ 5.5 GHz is below -10 dB, while in OFF state it has fine reflective property. In addition, inductances are used to connect each element of the structure to achieve the purpose of broadband isolation. Simulation and measurement results demonstrate the performance of the proposed structure.

Broadband Microwave Absorption Properties of a Frequency-Selective Surface Embedded in a Patterned Honeycomb Absorber

A Composite Absorber of FSS and Area-coated Honeycomb Using High-loss Materials for Broadband Applications

Frequency selective surface composites with honeycomb absorbing structure for broadband applications

Multisection Step-Impedance Modeling and Analysis of Broadband Microwave Honeycomb Absorbing Structures

Ultrabroadband Double-Sided and Dual-Tuned Active Absorber for UHF Band

An Ultra-Thin Broadband Active Frequency Selective Surface Absorber For Ultrahigh-Frequency Applications

Design of a Broadband Absorber Based on Antenna Reciprocity

Design of a Dual-Band Electromagnetic Absorber with Frequency Selective Surfaces

A Broadband Tunable Frequency Selective Surface Absorber For Oblique Incidence Applications

Design of a Broadband and Switchable Absorber Using an Absorb/Reflective FSS

Flexible Design and Realization of Wideband Microwave Absorber with Double-Layered Resistor Loaded FSS

Broadband Tunability of Polarization-Insensitive Absorber Based on Frequency Selective Surface

A THIN AND BROADBAND MICROWAVE ABSORBER BASED ON MAGNETIC SHEETS AND RESISTIVE FSS

Surface Impedance Modulation of FSS Composite Absorber for RCS Reduction at Normal and Grazing Incidence

An ultra-broadband multi-layer dielectric gradient honeycomb microwave absorber enhanced by the double layer metasurface

Thin and Broadband Electromagnetic Absorber Design Using Resistors and Capacitors Loaded Frequency Selective Surface

Broadband Frequency Selective Surface Absorber With Dual-Section Step-Impedance Matching for Oblique Incidence Applications

A Tuneable Microwave Absorber Using AFSS

Analysis FSS Absorber with Diversified Impedance for Broadband Applications

Frequency Selective Rasorber with Broadband Transmission Window Using Characteristic Modes Analysis

An Ultra-Wideband Metamaterial Absorber With Active Frequency Selective Surface