Abstract:PurposeThis paper aims to propose a calibration model for kinematic parameters identification of serial robot to improve its positioning accuracy, which only requires position measurement of the end-effector.Design/methodology/approachThe proposed model is established based on local frame representation of the product of exponentials (local POE) formula, which integrates all kinematic errors into the twist coordinates errors; then they are identified with the tool frame’ position deviations simultaneously by an iterative least squares algorithm.FindingsTo verify the effectiveness of the proposed method, extensive simulations and calibration experiments have been conducted on a 4DOF SCARA robot and a 5DOF drilling machine, respectively. The results indicate that the proposed model outperforms the existing model in convergence, accuracy, robustness and efficiency; fewer measurements are needed to gain an acceptable identification result.Practical implicationsThis calibration method has been applied to a variable-radius circumferential drilling machine. The machine’s positioning accuracy can be significantly improved from 11.153 initially to 0.301 mm, which is well in the tolerance (±0.5 mm) for fastener hole drilling in aircraft assembly.Originality/valueAn accurate and efficient kinematic calibration model has been proposed, which satisfies the completeness, continuity and minimality requirements. Due to generality, this model can be widely used for serial robot kinematic calibration with any combination of revolute and prismatic joints.

Comparative Analysis of the Kinematics Solution Based on the DH Method and Screw Theory

Kinematic Analysis of A New Hybrid Surgical Robot

Configuration and Kinematic Analysis of a Novel Hybrid Surgical Robot with a Ball Joint

The Kinematics Analysis of A Novel Self-Reconfigurable Modular Robot Based on Screw Theory

An Improved Kinematic Model for Serial Robot Calibration Based on Local POE Formula Using Position Measurement

Inverse Kinematics Analysis of Humanoid Robot Arm by Fusing Denavit–Hartenberg and Screw Theory to Imitate Human Motion With Kinect

Improved Inverse Kinematics Algorithm Using Screw Theory for a Six-DOF Robot Manipulator

Dynamic Modelling Using Screw Theory And Nonlinear Sliding Mode Control Of Serial Robot

Modeling Method of Autonomous Robot Manipulator Based on D-H Algorithm

Inverse kinematics sub-problem solution algorithm for serial robot based on screw theory

Complete Kinematics/Dynamics Modeling and Performance Analysis of a Novel SCARA Parallel Manipulator Based on Screw Theory

Kinematic Analysis of a Centrally Driven Humanoid Robotic Arm

Kinematics Analysis and Simulation of QJ-6R Welding Robot Based on Matlab

Research and Simulation of Modular Robot Arm Kinematics

Kinematic Analysis of Axial Piston Pump Based on Virtual Prototype

Kinematics and Dynamics Analysis of a 3UPS-UPU-S Parallel Mechanism

Kinematics Analysis and Simulation of Four-degree-of-freedom Serial Sampling Robot

Kinematic & Dynamic Analysis of the Human Upper Limb Using the Theory of Screws

An approach for mobility and force/motion transmissibility analysis of parallel mechanisms based on screw theory and CAD technology

Optimizing Redundant Robot Kinematics and Motion Planning via Advanced D-H Analysis and Enhanced Artificial Potential Fields

Kinematic Analysis of Novel Soft Robotic Arm Based on Virtual Work Principle.