Abstract:<p>Improving sludge drying efficiency is of tremendous importance for public health, subsequent treatment, and comprehensive utilization. The interfacial thermal resistance between sludge and hot wall greatly limits the conductive drying performance. This study employed mechanical compression to decrease the interfacial thermal resistance. The drying kinetics and interfacial heat transfer behavior were investigated at mechanical loads of 25 to 200 kPa, temperatures of 120 to 210 °C, and sludge thicknesses of 1.0 to 3.0 mm, and were compared to those in the conventional drying process without mechanical load. The increase of temperature and mechanical load and the decrease of thickness improved drying rates. The drying experienced one warm-up period and two falling rate periods. The breakthrough of interfacial vapor film was responsible for the rapid rise in drying rates initially. At the thickness of 3.0 mm, 210 °C, and 100 kPa, the effective moisture diffusivity was increased by 2.5 times, and the apparent activation energy was reduced by 34% compared to the traditional process in the first falling rate period, implying that mechanical compression facilitated moisture migration and bound water desorption. The effective moisture diffusivity in the first falling rate period was increased by 35% compared to the diffusivity in the second falling rate period because of the pressure-driven flow. The decrease in drying rates was due to the transformation from the pressure-driven flow to vapor diffusion-limited flow in the first falling rate period. Additionally, this study provided essential information on developing a new sludge treatment method and establishing the drying model.</p>

Experimental study on fluidization characteristics of sludge under different moisture contents

The Hydrodynamics of Low-Density Particles and Optimization of the EMMS Calculation Process

Experiment and Numerical Simulation on Slug Fluidization of Geldart D Particles

Experimental study on inhibition effect of chemical conditioning on low permeability sewage sludge layer under conditions of vacuum preloading

Measurement and Modelling of Moisture Distribution and Water Binding Energy of Dredged Sludge

Modeling of the Minimum Fluidization Velocity and the Incipient Fluidization Pressure Drop in a Conical Fluidized Bed with Negative Pressure

Application of Flocculation Combined with Vacuum Preloading to Reduce River-Dredged Sludge

Slurry Ability of Coal Water Slurry Prepared with Two Kinds of Sewage Sludge

Onset of slugging fluidization in supercritical water fluidized bed

RESEARCH OF COMBUSTION FUNDAMENTAL FOR HIGH DENSITY FLUIDIZED BED OF SLUDGE

Prediction of minimum fluidization velocity in pulsed gas–solid fluidized bed

The study of the separation and deposition of dredging soil slurry under physical disturbance

Investigation on the Minimum Fluidization Velocity of Mixture Containing Biomass Materials and Sands

Enhancement of conductive drying of sewage sludge with mechanical compression: Drying kinetics, and interfacial heat transfer behavior

Quantitative investigation on nucleation of flocculent sludge under different hydraulic conditions in anaerobic reactors

The effect of fine grits and fine debris concentrations on the MLVSS/MLSS ratio of an activated sludge system

Application of respones surface meth odology on impor vement fo S henf u coal slurryability

Research of Confirming Float Critical Velocity in Slurry

Systematic research on rheological behavior for flocculants-conditioned sludge suspension

Fundmental study on the semi-wet flue gas desulfurization with a MSFB

Numerical Simulation of Heat and Mass Transfer in Sludge Low-Temperature Drying Process