Abstract:This study aims to improve the ability of pre-service technology teachers to use 3D printing through an experiential learning activity. A three-step process was followed to achieve this goal: preparation, development, and improvement. During the preparation stage, preliminary skills and information needed to use 3D printers were identified and refined in a meeting with technology education experts. In addition, known problems in existing makerspaces were derived by analyzing their requirements and status. The need to develop an experiential learning activity to improve the 3D printing utilization ability of pre-service teachers was identified by analyzing technology teacher qualification standards, curriculums, and textbooks. During the development stage, the subject and content of the learning activity were determined using the requirement analysis obtained in the preparation stage. In particular, efforts were made to incorporate the required 3D-printing knowledge and skills identified in the preparation stage into this activity. The experiential activity task includes topics that enable individuals to learn the modeling and printing process during the three stages of 3D printing (modeling, printing, post-processing). The task can also be tailored, taking into account personal interests and ideas in real life. An 8-hour class was organized, which included two modeling practices. Then, teaching materials (teaching/learning guidance and class presentation materials), as well as learning materials (student activity sheets), were developed and evaluated by experts. As a result of the analysis of the questions in the multiple-choice questionnaire, it was determined that the content of the experiential activity task was suitable, with an average score of 4.50 or higher for all items. Based on other, more subjective evaluations, the experiential activity task and related data were revised and supplemented. During the improvement stage, a preliminary test was conducted with 46 undergraduate students of a technology education department. The test results were collected using a study satisfaction test sheet. For all items of this test, the average score was 4.20 or higher, which indicates a satisfactory level in all areas. After reflecting and expressing opinions, the experiential activity task was further modified and supplemented. This study yielded positive results in expert verification and preliminary testing with students, which reflects the proposed goal. The findings demonstrate the efficacy of the proposed revision and suggest that it can be valuable in enhancing the 3D printing skills of pre-service teachers as well as helping them design 3D printing classes to teach.

Application of 3D printing technology in petroleum engineering experimental teaching and practice of teaching reform

Application of 3D printing technology to Maker practical teaching

Application of 3D Scan - 3D Digital Reconstruction - 3D Printing Technology in Geological Engineering Teaching

Promoting Technology-Enhanced Project-Based Learning through Application of 3D Printing Technology for Mechanical Engineering Education

3D Printing for Experiments in Petrophysics, Rock Physics, and Rock Mechanics: A Review

Investigation and Practice of Engineering Practice Teaching Mode for Undergraduates of Chemical Engineering and Technology

The Implementation of 3D Printing in Engineering Education in the Field of Hydraulic and Pneumatic Components

Design and practice in engineering mechanics experimental teaching

Revolutionising Engineering Pedagogy: the Role of 3D Printing in Modern Engineering Education

Design and Implementation of a Virtual Experimental Teaching System for Deep Energy Exploitation Based on Digital Twin Technology

Application of Three-Dimensional Printing Technology to the Manufacture of Petroleum Drill Bits

The application of 3D geological modeling on below VII oil group in henan shuanghe oilfield

Exploration and Practice of Experimental Teaching for Water Supply and Drainage Science and Engineering

The Impact of Practical Experiences on the Development of Petroleum Engineering Education

Exploration and Practice on the Experimental Teaching Reform for Mechanical Design Basis Course

Influence of the use of 3D printing technology for teaching chemistry in STEM disciplines

Exploration and practice of experimental teaching based on research extension in mechanical engineering maj ors

Development and application of 3D printing technology in various fields

Developing Exploratory Experiments and Promoting the Training of Innovative Talents

Relying on the teaching and experimental base,constructing the new teaching system of engineering practice

Enhancing Pre-Service Technology Teachers' 3D-Printing Utilization Ability Through Experiential Learning