Abstract:Although road horizontal curves are high-risk sections for accidents, current road safety assessments often neglect the dynamic evolution of superelevation and the friction factor. The connotation for road safety level was clarified by examining the significance of road factors in traffic safety through the systemic characteristics of roads. Among these characteristics, curve safety level is determined by the ratio of the supply and demand of the lateral friction factor. On the basis of international standards and specifications, this study clarified the design supply and demand of friction factors for curve by considering the distribution of tangential and lateral friction factors. Expanding on the steady-state bicycle model while accounting for road geometric parameters and vehicle operation characteristics, the lateral friction factor demanded for vehicles was quantified. Meanwhile, the characteristics of the friction factor supplied and the superelevation variation were analyzed by using the road service life as a variable, along with their influence on the actual supply of the friction factor and the curve safety level. The results of the analysis indicate a rapid decrease in curve safety level during the first two years of road utilization, followed by a slower declining trend, with a significant 27% reduction in curve safety level by the end of the second year. Furthermore, the decline in the curve safety level is mainly attributed to variations in the road surface friction factor, whereas the influence of superelevation variation on the curve safety level is restricted. In the absence of maintenance interventions, the curve safety level will decrease by over 30% after three years of operation. Controlling operational speed is one of the effective measures for ensuring traffic safety. Meanwhile, the impact of the friction factor and the superelevation variation on the curve safety level accumulates over time, thus causing drivers to have difficulty perceiving these alterations. Therefore, dynamic safety evaluations that account for the fluctuation in the friction factor and superelevation induced by repetitive vehicle loading must be undertaken.

Pre-critical grade length of expressway based on reliability

Broaden Scheme and Optimization Design of High Slope Under Highway Operating Condition

Analysis approach and reliability analysis of cumulative cyclic deformation of subgrade of single high-speed railway line

Bridge Vehicle Load Model on Different Grades of Roads in China Based on Weigh-in-Motion (WIM) Data

An Efficient Probabilistic Design Approach for Tunnel Face Stability by Inverse Reliability Analysis

Methods of Reliability Analysis Based on Serviceability Limited State for Existing Reinforced Concrete Bridges

A Double-Layered Model for Highway Subgrade and Its Dynamic Response Due to Traffic Loads

An Optimization Design Method of Combination of Steep Slope and Sharp Curve Sections for Mountain Highways

Probabilistic Analytical Model for Settlement Risk Assessment of High-Speed Railway Subgrade

Design of foundation structures of sea-crossing bridges on serviceability limit state

Surface Deflection-Based Reliability Analysis of Asphalt Pavement Design

Application and Research on Shock Compression Limitation for Road Safety in Mountainous Areas

Structural response analysis of highways under heavy loads

Comprehensive Operation Risk Assessment of a Highway Maintenance Area Based on Reliability

Dynamic Reliability of Continuous Rigid-Frame Bridges under Stochastic Moving Vehicle Loads

Evaluation of the safety performance of highway alignments based on fault tree analysis and safety boundaries

Limited Response of Curve Safety Level to Friction Factor and Superelevation Variation under Repeated Traffic Loads

RELIABILITY-BASED ANALYSIS ON THE VEHICLE WEIGHT LIMIT OF HIGHWAY BRIDGES

Multi-parameter Dynamic Traffic Flow Simulation and Vehicle Load Effect Analysis based on Probability and Random Theory

Assessment of the transportation route of oversize and excessive loads in relation to the load-bearing capacity of existing bridges

Optimizing crash risk models for freeway segments: A focus on the heterogeneous effects of road geometric design features, traffic operation status, and crash units