Effects on bentonite microstructure by salt solution

Guosheng Xiang,Yongfu Xu,Shenghua Xie
DOI: https://doi.org/10.3969/j.issn.1001-0505.2016.S1.040
2016-01-01
Abstract:Nitrogen adsorption was conducted at 77 K to obtain the adsorption isotherm on the ben-tonite specimens inundated with distilled water and sodium chloride with different concentrations. Then,according to the adsorption data, the specific surface area, the pore volume, and the surface fractal dimension of bentonite specimens were calculated by BET,BJH and the Neimark thermody-namics methods,respectively. The test results show that with the increase of inundating solution con-centration,the pore volume of bentonite decreases,and the specific surface and surface fractal dimen-sion firstly decreases after an increased. It is found that this is due to the amount of Na+ coating the bentonite surface is different in different NaCl solutions. When the concentration of NaCl solution is higher,the Na+ adsorbed on bentonite surface is higher,and the Na+ will block the pore,leading to a smaller pore volume. Compared with the highly concentrated NaCl solution,a little of Na+ coating on the surface is more likely to cause a higher surface roughness,thus resulting in a high specific surface area and surface fractal dimension in NaCl solution with low concentration.
What problem does this paper attempt to address?