Abstract:A simple and general Equivalent Dynamic Stiffness Mapping technique is proposed for identifying the parameters or the mathematical model of a nonlinear structural element with steady-state primary harmonic frequency response functions (FRFs). The Equivalent Dynamic Stiffness is defined as the complex ratio between the internal force and the displacement response of unknown element. Obtained with the test data of responses׳ frequencies and amplitudes, the real and imaginary part of Equivalent Dynamic Stiffness are plotted as discrete points in a three dimensional space over the displacement amplitude and the frequency, which are called the real and the imaginary Equivalent Dynamic Stiffness map, respectively. These points will form a repeatable surface as the Equivalent Dynamic stiffness is only a function of the corresponding data as derived in the paper. The mathematical model of the unknown element can then be obtained by surface-fitting these points with special functions selected by priori knowledge of the nonlinear type or with ordinary polynomials if the type of nonlinearity is not pre-known. An important merit of this technique is its capability of dealing with strong nonlinearities owning complicated frequency response behaviors such as jumps and breaks in resonance curves. In addition, this technique could also greatly simplify the test procedure. Besides there is no need to pre-identify the underlying linear parameters, the method uses the measured data of excitation forces and responses without requiring a strict control of the excitation force during the test. The proposed technique is demonstrated and validated with four classical single-degree-of-freedom (SDOF) numerical examples and one experimental example. An application of this technique for identification of nonlinearity from multiple-degree-of-freedom (MDOF) systems is also illustrated.

Improved least squares complex f requency domain method and its application

A Kind of Improved Discrete Orthogonal Polynomials in Fourier Domain for Experimental Modal Analysis

A Fast Vibration-Level Adjustment Method for Low-Frequency Vibration Calibration Based on Modified Filtered-X Least Mean Square Algorithm

Iterative Algorithm for Identifying Multi-Modes Using Real Orthogonal Polynomials

Analysis and comparison of methods for frequency weighting based on an embedded system

Damping identification using weighted fitting of Frequency-response-function (WFF) method

Improved Method for Frequency-Domain Identifications of Structures

Numerical Analysis of a Fractional Nonlinear Oscillator with Coordinate-Dependent Mass

Stable parameters identification for rational approximation of Single degree of freedom frequency response function of semi‐infinite medium

Multi-frequency Identification Method in Signal Processing

Structural Damping Ratio Identification through Iterative Frequency Domain Decomposition

Parabolic fitting method for quality factor estimation

Non-Linear System Identification Using Frequency Domain Measurement Data

A Method of Nonlinearity Estimation and Correction Based on Difference Filtering

FRF-based pole-zero method for finite element model updating

Equivalent Dynamic Stiffness Mapping Technique for Identifying Nonlinear Structural Elements from Frequency Response Functions

High accuracy iterative frequency estimating algorithm based on the extremum of the DFT coefficients

An improved approximation method with adjustable zero and pole distributions for fractional order systems

Fast Bayesian modal parameter identification method based on short-time Fourier transform

Projection FxLMS Framework of Active Noise Control Against Impulsive Noise Environments

Adaptive Frequency Correction in LFMCW Radar Ranging