Abstract:The influence of the synthesis method parameters used to prepare nickel-based catalysts on the catalytic performance for the glycerol steam reforming reaction was studied. A series of Al2O3-supported Ni catalysts were synthesized, with nickel loading of 8 wt%, using the incipient wetness, wet impregnation, and modified equilibrium deposition filtration methods. The catalysts' surface and bulk properties were determined by inductively coupled plasma (ICP), N2 adsorption-desorption isotherms (BET), X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), and temperature-programmed reduction (TPR). Used catalysts were characterized by techniques such as elemental analysis and SEM in order to determine the level of carbon that was deposited and catalyst morphology. The results indicated that the synthesis method affected the textural, structural and surface properties of the catalysts, differentiating the dispersion and the kind of nickel species on alumina's surface. The formation of nickel aluminate phases was confirmed by the XRD and TPR analysis and the β-peak of the Ni/Al-edf catalyst was higher than in the other two catalysts, indicating that the nickel aluminate species of this catalyst were more reducible. Both Ni/Al-wet and Ni/Al-edf catalysts showed increasing CO2 selectivities and approximately constant CO selectivities for temperatures above 550 °C, indicating that these catalysts successfully catalyze the water gas shift reaction. It was also confirmed that the Ni/Al-edf catalyst had the highest values for glycerol to gaseous products conversion, hydrogen yield, allyl alcohol, acetaldehyde, and acetic acid selectivities at 650 °C and the lowest carbon deposition of the catalysts tested. The correlation of the catalysts' structural properties, dispersion and reducibility with catalytic performance reveals that the EDF method can provide catalysts with higher specific surface area and active phase's dispersion, that are easier to reduce, more active and selective to hydrogen production, and more resistant to carbon deposition.

Montmorillonite supported nickel nanoparticles for hydrogen production from glycerol steam reforming

Sol-Gel Preparation, Characterization and Hydrogenation Property of Silica Supported Ni Catalyst

Study of the Metal-Support Interaction and Electronic Effect Induced by Calcination Temperature Regulation and Their Effect on the Catalytic Performance of Glycerol Steam Reforming for Hydrogen Production

Glycerol Steam Reforming for Hydrogen Production over Nickel Supported on Alumina, Zirconia and Silica Catalysts

Renewable hydrogen production from steam reforming of glycerol by Ni–Cu–Al, Ni–Cu–Mg, Ni–Mg catalysts

Hydrogen production from steam reforming of glycerol by Ni–Mg–Al based catalysts in a fixed-bed reactor

Glycerol steam reforming over Ni/γ-Al2O3 catalysts modified by metal oxides

Comparison of gelatinous and calcined magnesia supported Ni or/and Co-based catalysts for aqueous phase reforming of glycerol

Ni-based catalysts supported on La/AlZn/AlLa oxides for hydrogen production via glycerol steam reforming

Hydrogen Production by Steam Reforming of Ethanol and Dry Reforming of Methane with CO2 on Ni/Vermiculite: Stability Improvement via Acid or Base Treatment of the Support

Hydrogen production from aqueous phase reforming of glycerol over attapulgite-supported nickel catalysts: Effect of acid/base treatment and Fe additive

Influence of calcination temperature of Ni/Attapulgite on hydrogen production by steam reforming ethanol

Synthesis and characterization of nickel based bimetallic nano catalyst for production of clean hydrogen by steam reforming of glycerol

Syngas production employing nickel on alumina‐magnesia supported catalyst via dry methane reforming

Nickel Supported on AlCeO3 as a Highly Selective and Stable Catalyst for Hydrogen Production via the Glycerol Steam Reforming Reaction

Boosting hydrogen production from steam reforming of glycerol via constructing moderate metal-support interaction in Ni@Al2O3 catalyst

Influence of the synthesis method parameters used to prepare nickel-based catalysts on the catalytic performance for the glycerol steam reforming reaction

Glycerol steam reforming over hydrothermal synthetic Ni-Ca/attapulgite for green hydrogen generation

Enhanced Biomass-Derived Glycerol Conversion to Syngas in the CO 2 Reforming Process: Influence of the Nickel Loading Method on Physicochemical Properties and Catalytic Performance

Plasma Assisted Preparation of Nickel-Based Catalysts Supported on CeO2 with Different Morphologies for Hydrogen Production by Glycerol Steam Reforming

Magnesium Promoted Hydrocalumite Derived Nickel Catalysts for Ethanol Steam Reforming