Method of high order Doppler frequency shift estimation for high-speed wireless communication

Minghua Jia,Xinggan Zhang
DOI: https://doi.org/10.13232/j.cnki.jnju.2016.06.016
2016-01-01
Abstract:Doppler effect is the main problem caused by high-speed movement of mobile terminal,which is a major contributing factor in decline in the quality of the communication system.The bit error rate(BER)and inter-carrier interference (ICI )increases that are attributed to large Doppler frequency shift.Research on the frequency compensation has important application value.Up to now,several methods have been proposed for estimating and compensating the one-order phase,such as level crossing rate(LCR),fast Fourier transform(FFT)and so on.Given that the high-order Doppler effect is less studied at present,the paper studies the problem of low precision and poor real-time performance of current Doppler shift compensation and a better compensation method in which the previous Doppler frequency shift and the changing rate are leveraged to estimate the current Doppler frequency shift is expected.The results show that the transverse motion of high-speed movement of the receiver will make the spectrum broaden,resulting in linear frequency modulated signal effect.And it cannot be compensated by conventional method.Furthermore,the high-order Doppler estimation and its compensation method are studied.The research indicates that the high-order spectrum is mainly composed of the transverse motion and the radial acceleration motion,and high-order spectral compensation can solve the impact of the majority of motion on the com-munication system including these two kinds of motion.And the phase difference is used to estimate the transverse velocity of terminal and then the frequency shift will be calculated.After that,the one-order and two-order phase compensation can be performed.Simulation results show the effectiveness of the method,and indicate that by combining the conventional Doppler estimation and the high-order Doppler estimation proposed in this paper,the signal can be effectively restoredand the BER can be reduced,even under low signal to noise ratio(SNR).
What problem does this paper attempt to address?