Abstract:Cu/SiO2 catalyst prepared by the ammonia-evaporation (AE) method is the potential preferred catalyst for hydrogenation of dimethyl oxalate (DMO) to ethylene glycol (EG). Although significant advancements have been obtained in the confirmation and influence factors of active species in the hydrogenation process, the relationship between the catalytic activity and the sensitive factors in the preparation or pretreatment process of the catalyst is still uncertain. In this paper, Cu/ZSM-5 catalysts for DMO hydrogenation to EG were prepared by the AE method using ZSM-5 molecular sieve with high silicon-alumina ratio (1500) as a support. The ZSM-5 support was pretreated by drying at 393 K for different hours and it was found that the surface hydroxyl group of the support had significant influence on the structure and catalytic hydrogenation performance of the prepared Cu/ZSM-5 catalyst. The distribution of surface hydroxyl groups could be significantly changed by pre-drying the carrier, which further resulted in the change of the copper dispersion and surface properties of subsequent copper-supported catalysts. With the decrease of hydroxyl content on the surface of the ZSM-5 support, the prepared reduced Cu/ZSM-5 catalyst possessed smaller Cu0 particles size, higher copper dispersion, higher surface area of Cu0 and Cu+ species, but weakened surface acidity of the catalyst, which resulted in the great improvement of the catalytic activity. The DMO conversion and EG selectivity could reach 100% and 93% even under the low reaction temperature at 448 K over the Cu/ZSM-5-24 catalyst (based on the ZSM-5 support pretreated by drying for 24 h). In addition, the catalytic activity did not show obvious change after 300 h of reaction, probably due to the low temperature reaction and suitable surface properties of the catalyst.Graphical Abstract

Effect of Supports on Copper-Based Catalysts for Dimethyl Oxalates Hydrogenation

Selective Hydrogenation of Dimethyl Maleate to Tetrahydrofuran over Cu/SiO2 Catalyst: Effect of Cu+ on the Catalytic Performance

Research on the Precursor of Catalyst Cu/SiO2 for Hydrogenation of Dimethyl Oxalate

Enhanced catalytic stability of Cu-based catalyst for dimethyl oxalate hydrogenation

Research on the Silica-Supported Copper Catalyst for Hydrogenation of Dimethyl Oxalate

Preparation and modification of Cu/SiO2 catalyst for hydrogenation of dimethyl oxalate to ethyl glycol

Effect of Si/Al Ratio of Mesoporous Support on the Structure Evolution and Catalytic Performance of the Cu/Al-HMS Catalyst

Textural Structure Effect Of Sio2 On The Catalytic Performance For Hydrogenation Of Dimethyl Oxalate To Ethylene Glycol Over Different Cu-Based Catalysts

Effects of Hydrogen and Hydrothermal Pretreatments on a Silica-Supported Copper Catalyst for CO Oxidation: Copper Hydroxy Active Species

Influence of support Si/Al ratio on performance of Cu/HZSM-5 catalyst for dimethyl oxalate hydrogenation

Enhanced Catalytic Performance for SiO2–TiO2 Binary Oxide Supported Cu-based Catalyst in the Hydrogenation of Dimethyloxalate

Role of Copper Content and Calcination Temperature in the Structural Evolution and Catalytic Performance of Cu/P25 Catalysts in the Selective Hydrogenation of Dimethyl Oxalate

Effect of Surface Hydroxyl Content of Support on the Activity of Cu/ZSM-5 Catalyst for Low-Temperature Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Effect of Cu Location and Dispersion on Carbon Sphere Supported Cu Catalysts for Oxidative Carbonylation of Methanol to Dimethyl Carbonate

Silver-modulated SiO2-supported copper catalysts for selective hydrogenation of dimethyl oxalate to ethylene glycol

The Nature of Active Copper Species in Cu-Hms Catalyst for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol: New Insights on the Synergetic Effect Between Cu-0 and Cu+

Effect of Initial Precipitation Temperature on the Structural Evolution and Catalytic Behavior of Cu/SiO2 Catalyst in the Hydrogenation of Dimethyloxalate

Cu/Sio2 Catalysts Prepared by the Sol-Gel Method for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Role of the Cu dopant in the textural and catalytic features of the Co/ZnO catalyst for dimethyl oxalate selective hydrogenation

The Support Effects on the Direct Conversion of Syngas to Higher Alcohol Synthesis over Copper-Based Catalysts