Abstract:As a renewable energy with zero carbon emission, the utilization of biomass has attracted widely studied. One of the most effective methods is to gasify the biomass into high-quality gas fuel. In the recent years, the majority of research on biomass gasification is conducted in the laboratory. However, it lacks the research in engineering application scale. In this work, a biomass gasification-combustion plant was designed and built to provide the industrial steam with a rate of 30 t/h for a food industrial park. The agricultural and forestry waste biomass was gasified in a gasifier, and then the product gas combusted in a boiler to supply the steam. The characteristics of the product gas from the gasifier were studied. The corrosion and pollutants in the combustion process were investigated. In the gasification process, the main components of the product gas are CO, H-2 and CH4. CO and H-2 account for 29.55 vol%-30.56 vol% and 11.65 vol%-15.35 vol%, respectively. The calorific value of the product gas is 5.88-6.29 MJ/m(3). The tar concentration is 110.58-155.07 g/Nm(3). At the outlet of the boiler, the concentration of the filterable particulate matter is 300.25 mg/Nm(3), and the particle size is concentrated at 1.00-2.50 mu m. The concentration of the condensable particulate matter (CPM) is 157.14 mg/Nm(3), and the proportion of water-soluble ions in CPM is 86.36 wt%. The concentration of Cl-, SO42-, NH4+ and Na+ in CPM is relatively high, with the values of 28.83 mg/Nm(3), 10.29 mg/Nm(3), 7.46 mg/Nm(3), and 5.06 mg/Nm(3), respectively. During the half-year running, the ash deposition and corrosion were detected in the boiler heating surface and the economizer. The ash deposit in the boiler is mainly composed of the sulfate and silicate, such as CaSO4, Zn2SO4, Na2SO4 and K3Na(SO4)(2). The ash deposit in the economizer is primarily composed of the sulfate and a small amount of alkali metal chloride. The flue gas reaches the emission requirement after passing through the pollution control devices and can be discharged into the atmosphere.

The Application of Biomass Molding Fuel Pyrolysis Gasification in Boiler

A Pilot Study on a 30t/h Biomass Gasification-Combustion Plant

A Pilot Study on a 30 T/h Biomass Gasification-Combustion Plant

Impact of the Reactor Structure on Biomass Pyrolysis in Fluidized-Bed Reactors: A Coarse-Grained CFD-DEM Study

Numerical Simulation and Multi-Process Coupling Analysis for Biomass Pyrolysis Fluidized Bed Reactor Based on Synergistic Effects Between Biomass and Nitrogen Inlet Modes

STUDY ON BIOMASS PYROLYSIS AND GASIFICATION IN A FLUIDIZED BED

Numerical simulation of biomass high-ratioco-firing in a pre-pyrolysis pulverized coal industrial boiler

Application of biomass pyrolytic polygeneration technology using retort reactors.

CFD simulation study of a biomass pellet-fuelled boiler

Pilot Development of Polygeneration Process of Circulating Fluidized Bed Combustion Combined with Coal Pyrolysis

Technical and Economic Feasibility of Combusting Biocarbon in Small Scale Pellet Boilers

PYROLYSIS CHARACTERISTICS OF STRAW ON A PILOT-SCALE GASIFICATOR

Experimental Investigation of Plastic Waste Pyrolysis Fuel and Diesel Blends Combustion and its Flue Gas Emission Analysis in a 5 Kw Boiler

Kinetics Study on Biomass Pyrolysis for Fuel Gas Production

Assessment of low‐rank coal and biomass co‐pyrolysis system coupled with gasification

Effects of Operating and Design Parameters on Biomass Pyrolysis to Produce Fuel Gas

Interconnected pyrolysis and gasification of typical biomass in a novel dual fluidized bed

Pyrolysis and Subsequent Direct Combustion of Pyrolytic Gases for Sewage Sludge Treatment in China

The combustion of torrefied biomass in commercial-scale domestic boilers

Thermal analysis technology to utilize waste biomass and waste heat to produce high-quality combustible gas through simulations and experiments

Analysis and Discussion of Biomass - Pyrolysis Gasification Technology