Abstract:In this paper, first principles method was adopted to investigate the point defects, Vanadium-related defects and defect combinations (vacancy (V), substitutional (S) and/or interstitial (I)) in molybdenum β-Mo2C and explore the use of first principles calculation data in analysing the link between different carbides and the effects of doping elements. Supercell models with different defect types were established and optimized, and the formation energy data of defects was developed. The structure evolution during the optimization process is analysed in detail to establish the main characteristics of changes and the relevant electronic properties. The data for different types of intrinsic defects and combined defects complexes was developed and key results is analysed. The results show that carbon vacancy (VC) is stable but does not inevitably exist in pure β-Mo2C. Interstitial site II is a very unstable position for any type of atoms (Mo, V and C), and analysis of the structure evolution shows that the atom always moves to the interface area near the interstitial site I between two layers. In particular, a C atom can expand the lattice structure when it exists between the layer interfaces. One type of the defects studied, the substitution of Mo with V (designated as 'SV-Mo'), is the most stable defect among all single point defects. The data for defect complexes shows that the combination of multiple SV-Mo defects in the super cell being more stable than the combination of other defects (e.g., 'VMo+IC', 'SV-Mo+VC'). The data with increasing SV-Mo in (Mo, V)2C system is developed, and typical data (e.g., formation energy) for Mo-rich carbides and V carbides are correlated and the potential of the data in analysing transition of different carbides is highlighted. The relevance of using first principles calculation data in the studying of V-doping and the complex carbides (V- and Mo-rich carbides) evolution in different materials systems and future focus of continuous work is also discussed.

First-principles Studies on Some Complex Materials

Effect of Anti-Site Point Defects on the Mechanical and Thermodynamic Properties of MgZn2, MgCu2 Laves Phases: A First-Principle Study

Defect physics in complex energy materials

The Structural, Elastic And Thermodynamic Properties Of Intermetallic Phases In Mg-Sn-Si-Ca(Sr) Alloys: A First-Principles Study

First-Principles Calculations of the Mechanical Properties of Doped Cu3P Alloys

Applications of First-Principles Method in the Research on Topological Materials

First-principles study of crystal structure prediction, electronic, thermodynamic and mechanical properties of Al-Li binary system

The Electronic Behaviors and Charge Transfer Mechanism at the Interface of Metals: A First-Principles Perspective

ENERGETICS OF METALLIC DEFECT AND ELECTRONIC STRUCTURE OF DOPED GRAIN BOUNDARY

Computational simulation of al-based alloy surface structure dislocation: the first-principles calculation and atomic pair-potential lattice dynamics calculation

First-principles calculations for understanding microstructures and mechanical properties of co-sputtered Al alloys

Insight into Point Defects and Complex Defects in β-Mo2C and Carbide Evolution from First Principles

Magnetic Effects at Surfaces and Interfaces (including Grain Boundaries)

First-principles Calculations of Bulk and Interfacial Thermodynamic Properties of the T1 phase in Al-Cu-Li alloys

First-principles calculations for point defects in solids

First-Principles Study of the Structural, Mechanical, Electronic, and Thermodynamic Properties of AlCu2M (M = Ti, Cr, Zr, Sc, Hf, Mn, Pa, Lu, Pm) Ternary Intermetallic Compounds

Development of Machine Learning and Empirical Interatomic Potentials for the Binary Zr-Sn System

First-principles investigation of the intrinsic defects in Ti3SiC2

First-principles study of extensive dopants in wurtzite ZnO

Experimental Measurements and Theoretical Calculations of the Atomic Structure of Materials with Subangstrom Resolution and Picometer Precision

First-principles thermodynamics of transition metals and alloys: W, NiAl, PdTi