Abstract:Rail surface defects will not only bring wheel rail noise during train operation, but also cause corresponding accidents. Most of the existing detection methods are manual detection, which is time-consuming, laborious, inefficient, and subjective. With the development of technology, automatic detection replaces manual detection, which reduces manual labor, improves efficiency, and objectively evaluates the surface state of rails, which is in line with the purpose of modern intelligent production. The automatic detection of a single sensor is usually not enough to complete the recognition, but multiple sensors need to be additionally installed and refitted on the service vehicle, which creates difficulty for on-site test conditions. Therefore, in order to overcome these shortages and to adapt to the actual vibration characteristics of service vehicles, a rail surface defect recognition method based on optimized VMD gray image coding and DCNN is proposed in this paper. Firstly, the optimization method of VMD mode number based on the maximum envelope kurtosis is proposed. The VMD after parameter optimization is used to decompose the four-channel axle box vibration signal, and the component with the largest correlation coefficient between each order eigenmode component and the original signal is extracted. Secondly, the filtered IMF components are arranged in sequence and encoded into grayscale images. Finally, the DCNN structure is designed, and the training set is input into the network for training, and the test set verifies the effectiveness of the network and realizes the recognition of rail surface defects. The test accuracy of railway data set measured on the serviced vehicle is 99.75%, and the results show that this method can accurately identify the category of rail surface defects. After adding Gaussian noise to the original signal, the test accuracy reaches 99.20%, which proves that the method has good generalization ability and anti-noise performance. Additionally, this method can ensure the safe operation of vehicles without adding new equipment, which reduces operation costs and improves the intelligent operation and maintenance of rails.

Dynamic Recognition of Deformation on Measured Rail ProfileBased on Convolutional Neural Network

Vision-Based Position Deviation Measurement of Rail Corrugation Chord Measuring Points under Bi-Linear Laser Assistance

An Efficient Approach for Guided Wave Structural Monitoring of Switch Rails Via Deep Convolutional Neural Network-Based Transfer Learning

Recognition and Calibration of Rail Profile under Affine-Distortion-Based Point Set Mapping

Deviation rectification for dynamic measurement of rail wear based on coordinate sets projection

MRSDI-CNN: Multi-Model Rail Surface Defect Inspection System Based on Convolutional Neural Networks

A Defect Detection Method for Rail Surface and Fasteners Based on Deep Convolutional Neural Network

Deep learning on rail profiles matching

Differential Deformation Identification of High-Speed Railway Substructures Based on Dynamic Inspection of Longitudinal Level

The Rail Surface Defects Recognition via Operating Service Rail Vehicle Vibrations

Quantification of Dynamic Track Stiffness Using Machine Learning

Laser Curve Extraction of a Train Wheelset Based on an Encoder-Decoder Network.

Error correction method based on dual-beam laser for curved rail profile measurement

Ballasted Track Behaviour Induced by Absent Sleeper Support and its Detection Based on a Convolutional Neural Network Using Track Data

A Multi-Modal Approach to Rail Surface Condition Analysis: the MFDF-Net

Predicting Rail Corrugation Based on Convolutional Neural Networks Using Vehicle's Acceleration Measurements

Automatic laser profile recognition and fast tracking for structured light measurement using deep learning and template matching

Research on deep learning method for rail surface defect detection

Intelligent identification of differential subgrade settlement of ballastless track system based on vehicle dynamic responses and 1D-CNN approach

Deep Learning and Laser-Based 3-D Pixel-Level Rail Surface Defect Detection Method

A Rail Surface Defect Detection Method Based on Pyramid Feature and Lightweight Convolutional Neural Network