Abstract:A continuous flow with reagent injection method on a novel inlaid microfluidic platform for nitrite determination has been successfully developed. The significance of the high-frequency monitoring of nutrient fluctuations in marine environments is crucial for understanding our impacts on the ecosystem. Many in-situ systems face limitations in high-frequency data collection and have restricted deployment times due to high reagent consumption. The proposed microfluidic device employs automatic colorimetric absorbance spectrophotometry, using the Griess assay for nitrite determination, with minimal reagent usage. The sensor incorporates 10 solenoid valves, four syringes, two LEDs, four photodiodes, and an inlaid microfluidic technique to facilitate optical measurements of fluid volumes. In this flow system, Taylor–Aris dispersion was simulated for different injection volumes at a constant flow rate, and the results have been experimentally confirmed using red food dye injection into a carrier stream. A series of tests were conducted to determine a suitable injection frequency for the reagent. Following the initial system characterization, seven different standard concentrations ranging from 0.125 to 10 μM nitrite were run through the microfluidic device to acquire a calibration curve. Three different calibrations were performed to optimize plug length, with reagent injection volumes of 4, 20, and 50 μL. A straightforward signal processing method was implemented to mitigate the Schlieren effect caused by differences in refractive indexes between the reagent and standards. The results demonstrate that a sampling frequency of at least 10 samples per hour is achievable using this system. The obtained attenuation coefficients exhibited good agreement with the literature, while the reagent consumption was significantly reduced. The limit of detection for a 20 μL injection volume was determined to be 94 nM from the sample intake, and the limit of quantification was 312 nM. Going forward, the demonstrated system will be packaged in a submersible enclosure to facilitate in-situ colorimetric measurements in marine environments.

Determination of Nitrate and Nitrite in Seawater by Continuous Flow Injection Analysis

Application of an Optical Nitrate Profiler to High- and Low-Turbidity Coastal Shelf Waters

Determination of Ammonia in Seawater by Multichannel Flow Injection Analysis

Simultaneous Spectrophotometric Determination of Nitrite and Nitrate in Water Samples by Flow-Injection Analysis

A High Precision Method for Calcium Determination in Seawater Using Ion Chromatography

Analysis of Ammonium in Seawater by Ion Chromatography with Single-Pump Column Switching

Field determination of nitrate in seawater using a novel on-line coppered cadmium column: A comparison study with the vanadium reduction method

Reversed phase flow injection-spectrophotometric determination of trace nitrite nitrogen in water

Determination of Ammonium in Seawater by Purge-and-Trap and Flow Injection with Fluorescence Detection

Flow-injection analysis with fluorescence detection for the determination of trace levels of ammonium in seawater

Sequential determination of multi-nutrient elements in natural water samples with a reverse flow injection system

Continuous Flow with Reagent Injection on an Inlaid Microfluidic Platform Applied to Nitrite Determination

Comparison of continuous flow analysis and ion chromatography for determinations of nitrate, nitrite and phosphate ions in seawater and development of related seawater certified reference materials

Green analytical method for simultaneous determination of salinity, carbonate and ammoniacal nitrogen in waters using flow injection coupled dual-channel C4D

Hyphenation Of C-18 Gel Silica Column And Flow Injection With Inductively Coupled Plasma-Mass Spectrometry And Its Application On The Seawater Analysis

Flow Injection Determination of Nitrite in Food Samples by Dialysis Membrane Separation and Photometric Detection

Determination of iodine species in seaweed and seawater samples using ion-pair reversed phase high performance liquid chromatography coupled with inductively coupled plasma mass spectrometry

Flow-Injection Catalytic Spectrophotometric Determination of Trace Amounts of Nitrite

Direct Determination of Nitrite Traces in High Ionic-Strength Samples by Electrostatic Ion Chromatography Using Diluted Acid Solutions As Eluent

An in situ analyzer for long-term monitoring of nitrite in seawater with versatile liquid waveguide capillary cells: Development, optimization and application

Flow injection on-line preconcentration and flame atomic absorption spectrometric determination of iron, cobalt, nickel, manganese and zinc in sea-water