Abstract:Numerical simulation is an important method to study the penetration into targets. Distinct results may be acquired if different kinds of software are adopted. In this paper, three kinds of commonly-used softwares (LS-DYNA, ABAQUS and PAM-CRASH) were adopted to simulate the same series of penetration experiments. The simulation results were analyzed and the advantages and disadvantages of each kind of software were compared. The purpose of this work is to help the researchers and engineers to select the most suitable software. The results in this paper demonstrate that the calculation results of the three kinds of software are basically consistent with the experimental results. The simulation results of the flat-headed projectile are generally better than those of the hemispherical projectile. The residual velocity of the projectile and the plug velocity were simulated well using all of the three kinds of software. The calculated velocities by ABAQUS and PAM-CRASH are closer to the experimental results, and the average relative errors are generally lower than 15%. Moreover, the errors from most calculation results by PAM-CRASH are even less than 10%. However, for the deformation of the projectile, the calculation results of the three kinds of software are quite different from the experimental ones. There are other differences in the performance of the three kinds of software. For example, the ballistic limits calculated by ABAQUS and LS-DYNA are higher than the experimental results, while those by PAM-CRASH are lower. ABAQUS is most likely to report errors but is balanced by calculation time and effects. LS-DYNA has a low error rate and good robustness. The change of model parameters (such as mesh density, friction coefficient, contact stiffness, viscous damping coefficient, etc.) has little effect on its calculation results. PAM-CRASH is greatly affected by model parameters. The conclusion of this paper is based on the following conditions: the target material is Weldox 460E steel, the projectile is ARNE tool steel, and the impact velocity range is 180－450 m/s. However, it is also of guiding significance for the penetration problem simulation of other materials in this velocity range.

Study on Similarity Law of Non-Proportionally Scaled Penetration/perforation Test

Study on the Equivalence of Penetration Overloading for Projectile-Borne Components in Nonproportional Penetrators

Study on fuze overload characteristic of high speed rocket in penetration process

Study on analogous experiment method for projectile penetration

Study on Target Structure Equivalent of Kinetic Energy Projectile Penetrating Concrete Target

Similarity Law Analyses of Penetration Behavior in Reinforced Concrete

Comparative study of numerical simulations of projectile penetration into metal targets

The Study on Rate-dependent Similarity Law of High Velocity Penetration into Concrete Target

Study on Acceleration Test Technique of High Velocity Kinetic Energy Projectile Penetrating into Hard Target

Similarities in the Penetration Depth of Concrete Impacted by Rigid Projectiles

A Computational Study on the Overload Characteristic Curves of Projectile Penetrating Metal Object

Numerical Study on Penetration Performance of Low-velocity Flat-nose Projectile into Two-Laminated Target

Experiment and simulation for projectile penetrating concrete target with finite thickness

Scaled Experiment of the Detonation Control System for the High-Speed Penetration on Concrete

Study on Penetration of Concrete Targets by Ogive-Nose Steel Projectile

Numerical simulation of high speed penetration into concrete by steel projectiles

Thick Plain Concrete Targets Subjected to High Speed Penetration of 30crmnsini2a Steel Projectiles: Tests and Analyses

Experimental Studies on Kinetic Projectile's Direct Penetrations with Low-speed Against Reinforced Concrete Targets

Comparability Law about Simulation Experimentation of Kinetic Penetrator Penetrating Concrete Target

Analysis of the influence of different initial velocities on dynamic performance of multi-layer hard target penetration process

Failure analysis of semi-infinite concrete targets subjected to tubular projectiles impact