Effect of blockage ratios on the characteristics of methane/air explosions suppressed by dry chemicals

Ligang ZHENG,Gang LI,Yalei WANG,Xiaochao ZHU,Zengguo Dou,Depeng DU,Minggao YU
DOI: https://doi.org/10.11883/bzycj-2018-0228
2019-01-01
Abstract:To investigate the effect of blockage ratios (φ) on the inhibited flame, an experimental study was performed to suppress the methane-air explosions in a 5 L duct with the blockage ratios φ = 0, 0.2, 0.4, 0.6, 0.7, 1.0 under BC and Al(OH)3 inhibitors with the mass concentrations C = 0 g/m3, 80 g/m3, 160 g/m3 and 240 g/m3. The results indicated that the flame fragmentation increased with the improvement of the suppression efficiency. The maximum explosion pressure (pmax) and the deflagration index of the explosion (Kst) were dominated by the combustion rate and the discharge rate. Furthermore, φ = 0.7 was the inflection point of pmax and Kst curves. The drop rate in the Pmax (δ) firstly increased and then decreased as the blockage ratio increased. And the maximum δmax was achieved at the blockage ratio between 0.4 with 0.6. In general, the suppression efficiency of Al(OH)3 and NaHCO3 powders was comparable. However, the low turbulence caused by certain blocking ratios impacted the sedimentation of inhibitor particles, which made the suppression efficiency of Al(OH)3 better than that of NaHCO3. There was an increasing heat resistance as the powder concentration increased from 80 g/m3 to 240 g/m3, which blocked the penetration of heat from the flame into the interior of particle cloud and disabled interior particles’ thermal decomposition, leading to a weakening concentration effect.
What problem does this paper attempt to address?