Abstract:By using the transient finite element method, a three-dimensional wheelset-track coupled rolling contact model for high-speed rail is established, and the rationality and effectiveness of the model are verified by field measurements. Next, the wheel-rail contact stress states and relative slip characteristics are calculated and analyzed to reveal the cause of inner rail corrugation. Then, the vertical vibration acceleration of the rail/wheel is taken as the output variable to study the dynamic responses of the wheelset-track system. Finally, the parameter sensitivity analysis is carried out. The results show that the maximum normal/tangential contact stress between the inner wheel and inner rail is greater than that between outer wheel and outer rail due to the unbalanced load of inner rail caused by the excess superelevation of track structure, which indicates that the unbalanced load of the inner rail may aggravate the development of rail wear, and the rationality of the model established in this paper is verified. The wheel-rail relative slip region on the inner rail side appears periodically, and the distance between the two adjacent slip regions is close to the characteristic wavelength of the measured inner rail corrugation, which illustrates that the periodic variation of slip regions on the inner rail surface plays an important role in the formation of rail corrugation, and the validity of the model is verified. The periodic distribution of wheel-rail relative slip regions on the outer rail surface is not obvious, demonstrating that the outer rail tends to form uniform wear, which is consistent with the fact that the outer rail corrugation is slight in the measured section. The wheelset-track system has been in the process of unstable continuous oscillation in the analysis interval, combined with the analysis results of the wheel-rail relative slip characteristics, it can be concluded that the unstable self-excited vibration of wheelset-track system under the condition of tangential contact force reaching saturation is the main cause of rail corrugation. The dominant characteristic frequencies of vertical vibration accelerations of rail and wheel are all 561 Hz, the corresponding characteristic wavelength (148 mm) is close to the distance (150 mm) between the calculated adjacent slip regions, and is also close to the characteristic wavelengths (125 mm and 160 mm) of inner rail corrugation, which shows that the resonance phenomenon occurs in the wheelset-track system at the above frequency, thus leading to the increase of dynamic responses of wheelset-track system. The fastener vertical stiffness and wheel-rail coefficient of friction have significant effect on the development of rail corrugation, and the running speed determines the occurrence probability of inner/outer rail corrugation by affecting the track superelevation state.

Shakedown Analysis of Rolling Contact Surface with Short-Wavelength Corrugation

Mechanism of Short Wavelength Corrugation of Rail Surface

Analysis of Wheel/Rail Contact Stresses and Rail Corrugation

Investigation on the transient rolling contact behaviour of corrugated rail considering material work hardening

Analysis of rail corrugation deterioration behavior on a heavy-haul railway

An investigation into rail corrugation due to micro-slip under multiple wheel/rail interactions

Study on the evolution of material microstructure and constitutive relation during rail corrugation development

Analysis of Rail Corrugation Characteristics on High-Speed Rail Based on Transient Finite Element Method

Wheel-rail rolling contact behavior induced by both rail surface irregularity and sleeper hanging defects on a high-speed railway line

Three-dimensional elastic–plastic stress analysis of wheel–rail cyclic rolling contact using finite element method

Influence of shear yield strength of rail material on the shakedown limit in shakedown map

Effects of decarburized Layer's material property on the rail corrugation development

Numerical investigation on wheel-rail impact contact solutions excited by rail spalling failure

Influence of material properties on the high-speed wheel-rail rolling contact behaviour

Evolution of microscopic characteristics of rolling contact fatigue coexisting with wear of U75V rail

Numerical tribology of the wheel-rail contact : Application to corrugation defect

Study on the Formation Mechanism for High Rail Corrugation

Investigation on the causes of rail corrugation in high-speed railways based on the wheel–rail transient rolling contact model and wear model

Analysis of rail corrugation characteristics based on PSD

An elastic-plastic theoretical analysis model of wheel-rail rolling contact behaviour

Study on wear and rolling contact fatigue behaviours of defective rail under different slip ratio and contact stress conditions