Quantitative analysis of water quality parameters COD measurement based on spectral data fusion
Qing Chen,Mingfu Zhao,Ninghui Yang,Linfeng Cai,Jinfu Zhang,Junfeng Miao,Qisen Xiao,Bin Tang,Han Liu,Zourong Long
DOI: https://doi.org/10.1117/12.2656746
2022-10-20
Abstract:UV-Vis absorption spectroscopy is often used to measure COD values. At present, certain points or wavelengths in the spectrum are often obtained for modeling, resulting in deviations in predicting COD values. Aiming at this problem, this study adopts a data fusion method of multi-source spectroscopy (Raman spectroscopy and UV-Vis absorption spectroscopy) to improve the accuracy of predicted COD values. In the experiment, two groups of single spectrum and multi-source spectrum were used for comparison. Potassium hydrogen phthalate was used to simulate the COD value of water quality. The range of COD was 5-100mg/L, and the concentration gradient was 5mg/L. The data fusion of multisource spectra in the experiment uses the normalization method to remove the dimension and then cascades into a new data set matrix. The eigenvalues are screened out through the importance analysis of projection variables, and finally the processed matrix is combined with the partial least squares regression method. The experiment was modeled with 19 training groups, and 1 group was used to verify whether the model was good or bad. The experimental results use the two dimensions of root mean square error and coefficient of determination to evaluate the quality of the model. UV-Vis absorption spectrum R2=0.9993, RMSECV=1.8525; data-level fusion R2=0.9668, RMSECV=1.6113; feature-level fusion R2=0.9766, RMSECV=1.2957. The experimental results show that multi-source spectral fusion has a positive impact on improving the detection of water quality parameters, and the fusion model has stronger predictive ability.
Environmental Science,Chemistry,Engineering