3D Imaging of Nanoalloy Catalysts at Atomic Resolution
Jihan Zhou,Yongsoo Yang,Zipeng Zhao,Colin Ophus,Peter Ercius,Yu Huang,Jianwei Miao
DOI: https://doi.org/10.1017/s1431927617010820
IF: 4.0991
2017-01-01
Microscopy and Microanalysis
Abstract:Metal catalysts such as Pt, Pd, Cu, and Ni are critical components in many applications ranging from fuel cells in automobiles to mobile power generation. Recent studies have shown that introducing earthabundant metals such as Ni and Cu into Pt can not only significantly enhance the oxygen reduction reaction (ORR) activity of the catalysts, but also lower the cost [1, 2]. Among these nanoalloys, bimetallic platinum-nickel (PtNi) nanostructures represent an emerging class of candidates for ORR catalyst in fuel cells. More recently, a new nanoalloy catalyst of carbon-supported NiPt with Mo doped on the surface (PtNi-Mo) has been reported, demonstrating 80-fold enhancements compared with commercial Pt-C catalyst [3]. To understand the structure and performance of these nanoalloy catalysts, it is essential to fully characterize the surface structure of these nanoalloy catalysts in 3D with atomic resolution. An ideal method to achieve this challenging goal is atomic electron tomography (AET) [4], which retrieves 3D atomic structure information from a tilt series of high-resolution 2D images. In recent years, AET has been used to image the 3D structure of grain boundaries, stacking faults, and the core structure of edge and screw dislocations at atomic resolution [5, 6]. Furthermore, the combination of AET and atom tracing algorithms has enabled the determination of the coordinates of individual atoms and point defects in materials with a 3D precision of ~19 pm, allowing direct measurements of 3D atomic displacements and the full strain tensor [7]. More recently, the 3D coordinates of more than 23,000 atoms in an FePt nanoparticle have been determined by AET to correlate chemical order/disorder and crystal defects with material properties at the single-atom level [8]. Here, we apply AET to probe the 3D surface atomic structure of PtNi-Mo nanoalloy catalysts. By using the TEAM microscope at the National Center for Electron Microscopy at LBNL, we have acquired several tomographic tilt series from PtNi-Mo nanoalloys. After post processing and centre of mass alignment of the tilt series, we computed high-quality 3D reconstructions by using a Generalized Fourier Iterative Reconstruction (GENFIRE) algorithm [8]. Volume-renderings of a representative 3D reconstruction show individual atoms at different orientations (Fig. 1). The individual Pt, Ni and Mo atoms can be distinguished based on the intensity contrast. Figure 2 shows three perpendicular 1.7 Å thick central slices of the atomic resolution reconstruction, where red and blue arrows indicate Pt and Ni atoms, respectively. With further improvement of the tilt series alignment, denoising and tilt angle refinement, we expect the full determination of the 3D atomic structure of PtNi-Mo nanoalloys, including precise atomic coordinates and accurate classification of Pt, Ni, and Mo atoms. Coupled with first principles calculations, the full surface oxygen binding energy map can be derived from the 3D atomic structure, providing essential information to precisely tailor and optimize the catalytic behavior for various applications [9].