Abstract:A 1.5 MW final power amplifier is to be developed for ion cyclotron resonance heating (ICRH) system for the China fusion engineering testing reactor (CFETR) project. First, the feasibility of driver power amplifier with input matching circuit and output resonator cavity and a newly developed tetrode was cross-verified through three-dimensional (3D) simulations and experiments. A single coaxial cavity in parallel with the tetrode covered the frequency range of 40 to 100 MHz at a 100-kilowatt level. In contrast to the previous method of deducing matching parameters using RF circuit and transmission line theory, the use of 3D transmitter simulations pro-vided more accurate matching parameters of tuning components at different operating frequencies. A new phenomenon of high frequency oscillation between the short strip inductor and the shield cavity was found in the input simulation results, which was subsequently verified by experiments. Specific reasons for dividing the output into two parts of high and low frequency were found through output circuit simulations. One is that the length of short stub decreases with the increase of operating frequency, thus decreasing the frequency resolution if all frequencies were using low frequency port. The other is that the coupling capacitor increases sharply with the increase of frequency due to parasitic effect in the low output. Further, the simulation facilitated the study of parasitic effects on matching parameters caused by strip-inductance, inter electrode capacitances of tetrode, and RF cavity. Thus, facilitating the design of final power amplifier in the future. Finally, the amplifier installed with the new tetrode DB968 achieved the design objectives in the test experiment with 150 and 110 kW power outputs at 48 and 100 MHz, respectively.

Numerical Simulation And Analysis Of Ssc Rf Cavity

The Validation of the Simulated HIRF Effects in Metallic Cases Using Parallel FDTD Solver on a High Performance Computer

Multi-physics Field Coupling Analysis of RFQ Cavity for SSC-LINAC

The Application of the NIPC Method and the FSV Method on the Validation of EM Simulation under HIRF Environment

Multi-physics Analysis and Experiment of a CW Four-Rod RFQ

Design and Simulation of 500 MHz Single Cell Superconducting RF Cavity for SILF

Particle-In-Cell Simulation of RFQ in SSC - Linac

Simulation and Experimental Studies on a 4 Rod RFQ RF Property

Three-dimensional Modeling and Simulation of RF Cavity for a Transmitter with Bandwidth of 40–100 MHz at 100-Kilowatt Level

Numerical Experiment of RF Performance for 70 MHz Cyclotron Cavity

Design and Measurements of SFRFQ Cavity

Theoretical Investigation And Simulation Of Resonant System Of Sector And Hole-And-Slot Resonator Type Rising-Sun Magnetron

Simulation of a Double-gap Coupled Cavity Based on Finite Element Method

Design and Cold Measurements of a Coupled RFQ-SFRFQ Cavity

Design and primary test of full scale cavity of cyciae-100

Procedure of simulations for Evaluations of Transient Parameters Stability for RF Cavities Due to Effects of Pulsed RF Heating

Recent Progress of a CW 4-Rod RFQ for the SSC-LINAC

Design And Simulation Of A Cooling System For The High Current 4-Rod Rfq Cavity

THE STUDY OF SEPARATED FUNCTION RFQ (SFRFQ) WITH DIAPHRAGMS

Power Test of the Separated Function RFQ Accelerator

Theoretical Analysis And Simulation Of Resonant System Of High Power Continuous Wave Magnetron