Carbon Nanotubes As A Secondary Support Of Catalyst Layer In Oxygen Diffusion Electrode And Their Electrochemical Properties

H Huang,Wk Zhang,Yp Gan,Xb Zhang,Jp Tu
DOI: https://doi.org/10.3969/j.issn.1674-0068.2005.03.026
IF: 1.09
2005-01-01
Chinese Journal of Chemical Physics
Abstract:A novel gas diffusion electrode using binary carbon supports ( carbon nanotubes and active carbon ) as the catalyst layer was prepared. The electrochemical properties for oxygen reduction reaction( ORR ) in alkaline electrolyte were investigated by polarization curves and electrochemical impedance spectroscopy. The results show that the binary-support electrode exhibits higher electrocatalytic activity than the single-support electrode, and the best performance is obtained when the mass ratio of carbon nanotubes and activated carbon is 50 : 50. The results from their electrode kinetic parameters indicate that the introduction of carbon nanotubes as a secondary support provides high accessible surface area, good electronic conductivity and fast ORR kinetics. The electrocatalytic activity of binary-support electrodes is obviously improved by the deposition of Pt nanoparticles on carbon nanotubes, even at very low Pt loading (45.7 mu g/cm(2)). In addition, the EIS analysis results show that the process of ORR may be controlled by diffusion of oxygen in the thin film for binary-support electrodes with or without Pt catalyst.
What problem does this paper attempt to address?