Numerical inversion of deformation caused by a pressurized magma chamber: an example from the Changbaishan volcano

Huang LuYuan,Cheng HuiHong,Zhang Huai,Gao Rui,Shi YaoLin
DOI: https://doi.org/10.6038/cjg2020N0012
2020-01-01
Chinese Journal of Geophysics
Abstract:Volcanoes are commonly associated with significant topographic relief. However, most analytical models of volcanoes consider the Earth's surface as flat. Ordinary FEM simulations are mesh dependent which imposes remeshing to define any change in the position of the pressure source in forward modeling which may cause huge computing time and mesh generation time. To solve this problem, the inversion of volcano deformation based on the equivalent body force method is adopted in a case study of the Changbaishan volcanic area. The results show that the shallower the magma chamber is, the greater the effect of topography shows up. In the case of topography relief, when the magma chamber becomes shallower, the ground maximum radial displacement usually occurs above the center of the magma chamber. It appears that the steeper the volcano, the ground maximum vertical displacement farther from the center. For a volcanic cone with an average slope of 30 degrees, the maximum surface vertical displacement is not located above the center of the magma chamber, instead appearing as a ring on the slope. The surface deformation caused by an ellipsoidal magma chamber fits well with the observed GPS and leveling data. The interaction between regional and magma-induced stresses can explain the present stress orientations around the volcano inferred from stress measurements. The Coulomb failure stress changes due to magmatic eruption may promote the earthquake swarms with NW-trending fault planes clustering in two regions: the northeastern part and the southwestern part of the caldera during 2002-2003.
What problem does this paper attempt to address?