Dynamic Deformation Characteristics of Remolded Red Clay Under Bi-directional Dynamic Load

Mipeng WANG,Yasheng LUO,Jianlong LIU,Yan LI
DOI: https://doi.org/10.3969/j.issn.1000-0844.2017.06.1046
2017-01-01
Abstract:The dynamic shear modulus and damping ratio are important parameters for describing the dynamic characteristics of the soil.In this study,the dynamic deformation characteristics of red clay under bi-directional dynamic load was investigated by using a SDT-20 dynamic triaxial apparatus.The impact of moisture content,consolidation stress,consolidation ratio,and radial dynamic load amplitude,on the dynamic deformation characteristics of red clay,such as the hys-teresis loop,dynamic shear modulus,dynamic stress-strain relationship,and damping ratio, were analyzed.The experimental results show that when the phase difference was 0 and all other conditions were the same,the dynamic shear modulus of the red clay decreased with the increase of radial dynamic load amplitude.The relationship between the dynamic shear strain of the red clay and vibration frequency was approximately demonstrated by an exponential function under a bi-directional dynamic load,and there was a critical cycle number Ndc.With the increase of mois-ture content and consolidation stress,the failure mode of red clay changed from tensile damage to compression damage.Tensile damage was more likely to happen with the increase of radial dy-namic load amplitude.The change of the damping ratio did not present a certain rule with the in-crease of dynamic shear strain under bi-directional dynamic loading.When the dynamic shear strain was less than 1%,there was no regular pattern in the change of the damping ratio,while the dynamic shear strain was more than 1%,and the damping ratio was stable with the increase of dynamic shear strain.The radial dynamic load amplitude had no obvious impact;however,the moisture content had an effect on the damping ratio.When the moisture content was less than 20%,the damping ratio increased with the increase of moisture content;while the moisture con-tent was more than 20%,its influence on the damping ratio was negligible.This study could be used as a reference for the further design of dynamic deformation characteristics and numerical calculation.
What problem does this paper attempt to address?