Abstract:The purpose of this study was to optimize quantitative electron energy loss spectroscopy (EELS) of elements that have characteristic edges in the low energy loss region and are components of organic matrices. The optimum parameters for phosphorus L2,3-edge (at 135 eV) detection were determined by numerical analysis of computer-generated, Poisson-noisy spectra and by experimental measurements (at 80 keV) of films of the phosphoprotein, phosvitin. When the first, second and third valence electron/plasmon scatterings are included in the multiple least-squares (MLS) fit, the background subtraction of (first-difference) spectra is significantly more accurate than that obtained with the “inverse power law” method, even for a specimen thickness of only 0.25λ. Taking into account the effects of plural scattering, the optimal thickness for P quantitation is approximately 0.3λ. Signal-to-noise (S / N) ratio decreases rapidly with thickness, and at 1.0λ, it is only about 60% of the optimum S / N. The combined effects of the statistical uncertainty of measurements and of the systematic error due to gain variations of the parallel detector were evaluated, and the relative sensitivities of the no-difference (raw spectrum), first-difference and second-difference methods were compared. For channel-to-channel gain variations greater than 0.1% and up to 0.8%, the first-difference method results in the lowest uncertainty of P measurements. In the absence of gain variations, direct fitting provides the greatest sensitivity (least uncertainty), whereas at larger gain variations it may be necessary to use the second-difference method. The optimum energy shift for collecting a first-difference spectrum, approximately 15 eV, did not show any great variation between 5 and 25 eV, and is, in general, specimen dependent. Quantitation with EELS showed excellent correlation with simultaneous electron probe X-ray microanalysis, but, for the detection of P in a 0.25λ thick specimen, EELS was approximately five to six times more sensitive than X-ray. The minimal detectable P concentration, with 0.5 nA beam current for 100 s in a 0.25λ thick specimen, was 8.4 mmol/kg (0.01 at%) at the 99% confidence level, equivalent to 34 phosphorus atoms for a 15 nm probe. This value is close to the theoretical prediction of 7.5 mmol/kg, and can be improved only by further reducing the gain variation and directly fitting the non-difference spectrum. Appropriate reduction of the gain variations to less than 0.1% would result in a further, approximately two-fold, improvement in the parallel EELS detection system. However, in order to obtain the optimal specimen thickness for phosphorus quantitation in cryosections, it will be necessary to use higher (approximately 200 keV) excitation voltages.

MASS LOSS OF QUANTITATIVE ELECTRON PROBE X RAY MICROANALYSIS FOR BIOLOGICAL THIN SPECIMEN

Electron probe microanalysis of biological soft tissues: principle and technique

Calcium Quantitation with a Parallel Electron Energy Loss Spectroscopy/Cooled Charge-Coupled Device/200 Kev System

The Effects of Non-Uniform Specimen Thickness on Thickness Determination and Elemental Quantitation with Electron Energy Loss Spectroscopy (EELS)

Optimization of Quantitative Electron-Energy Loss Spectroscopy in the Low-Loss Region - Phosphorus L-Edge

Evaluation of a preparative method for x-ray microanalysis of soft tissues

Quantitative EELS Mapping of Biological Thin Sections

Improved precision of quantitating calcium in biological electron probe analysis.

Thickness Measurements by Electron Energy Loss Spectroscopy (EELS)

Some Problems and Solutions in Electron Energy Loss Spectroscopy of Cryosections

Quantitative Proteomic Analysis for Radiation-Induced Cell Cycle Suspension in 92-1 Melanoma Cell Line

Dynamic Analysis of major elements in biological tissue validating quantification of trace life elements in MeV ion beam microscopy

A Study of Energy Loss and Straggling of MeV Protons in Biological Samples

Influence of Electron Dose Rate on Electron Counting Images Recorded with the K2 Camera.

Thickness Determination of Biological Thin Sections by Multiple-Least-squares Fitting of the Carbon K-edge in the Electron Energy-Loss Spectrum

Quick sampling and perpendicular cryosectioning of cell monolayers for the X-ray microanalysis of diffusible elements

Energy Loss and Straggling of MeV Energy Ions Through Biological Samples

Study of the Impact of Sample Thickness on Thin Film Method X-Ray Fluorescence Spectrum Measurement

Could biological tissue preservation methods change chemical elements proportion measured by energy dispersive X-ray spectroscopy?

Impact of Sample Preparation Methods on Single-Cell X-ray Microscopy and Light Elemental Analysis Evaluated by Combined Low Energy X-ray Fluorescence, STXM and AFM

Synchrotron Radiation XRF Microprobe Investigation of Elemental Distribution in Femoral Head Slice with Osteoporosis