Abstract:The glass bead is a new biochip support material for immobilization biomolecules, due to its independence and convenient rearrangement. In order to optimize the immobilization efficiency of oligonucleotides onto glass beads and obtain the highest hybridization efficiency, three commonly used coupling strategies have been studied for covalently attaching oligonucleotides onto large glass beads. Glass beads with 250 μm diameter were amino-silaned with 2% 3-aminopropyltrimethoxysilane (APTMS) and then reacted separately with glutaraldehyde, succinic anhydride and 1,4-phenylene diisothiocyanate (PDITC) to derive CHO beads, COOH beads and isothiocyanate-modified beads (NCS-Beads) accordingly. Afterwards, amino-terminal oligonucleotides were covalently attached onto the surface of beads achieved by three strategies mentioned above. The immobilization efficiency were studied to compare the three strategies, which turned out 2.55 × 1013 probes/cm2 for CHO-Beads, 3.21 × 1013 probes/cm2 for COOH beads and 6.68 × 1013 probes/cm2 for NCS beads. It meant that the immobilization efficiency based on NCS beads was most acceptable. And the method, developed by attaching amino-terminal oligonucleotides onto these cyanate active beads, could be regarded as an efficient one for immobilizing oligonucleotides onto a solid surface. Moreover, in this paper, the hybridization properties of NCS bead-based oligonucleotides have been studied by employing Cy5-tagged complementary oligonucleotides. It was found that the high probe density NCS beads led to low hybridization efficiency possibly due to the existence of steric crowding. In addition, the equilibrium binding constant K A was determined by employing Langmuir isotherm model, which was 7.0 × 106 M−1 for NCS beads with the density of 6.7 × 1013 probes/cm2. Furthermore, it only took 60 min to reach hybridization equilibrium. These large microspheres (>100 μm) can be employed in the mesofluidic systems for automated heterogeneous assays.

THE FABRICATION AND OPTIMIZATION OF Cdna ARRAYS ON THE GLASS SURFACE

Immobilization and Hybridization of Cdna Arrays on the Glass Surface

Effect of Target and Probe Concentrations on Hybridization in Dna Microarrays

Optimization and Development of DNA Microarray Technique

Assembly Method Fabricating Linkers for Covalently Bonding DNA on Glass Surface

DNA microarray synthesis by using PDMS molecular stamps (III)—Optimization for the reaction conditions

Characterization of Oligodeoxyribonucleotide Synthesis on Glass Plates

Binary DNA Arrays on Heterogeneous Patterned Surfaces

Assembly Fabrication of Linkers on Glass Surface and Their Effect on DNA Synthesis and Hybridization

Optimization of On-Chip Elongation for Fabricating Double-Stranded DNA Microarrays

Genochips - Comparative Studies on Two Different Methods for Immobilization of Dna Probes on Glass Surfaces

DNA Detection on Plastic: Surface Activation Protocol to Convert Polycarbonate Substrates to Biochip Platforms

Manufacture of Complementary Dna Arrays on Amino-Modified Slides

DNA Amplification on a PDMS–glass Hybrid Microchip

Enhancing Deoxyribonucleic Acid (DNA) Detection Sensitivity Through Microconcentration on Patterned Fluorocarbon Polymer Surface.

Combing DNA on CTAB-coated surfaces.

Construction of DNA microarrays on cyclic olefin copolymer surfaces using confined photocatalytic oxidation

Optimization the preparation of tetracyclines and β-lactam antibiotic-resistant genes microarrays

Optimal Condition Of The Microarray Of Single-Stranded Deoxyribonucleic Acid Probe On Carboxylate Polystyrene Bead Surface And The Hybridization Of Microarrayed Probe At Solid-Liquid Interface

Different Strategies of Covalent Attachment of Oligonucleotide Probe Onto Glass Beads and the Hybridization Properties

In situ synthesis of oligonucleotide arrays by using the molecular stamp method