Abstract:Researches of flow and dispersion in urban area are important to meet the practical demands of studies of vehicular exhaust pollution and accidental leakage. Numerical simulations with field observations and physical simulations (e.g., wind tunnel simulation) are often used to address atmospheric flow and dispersion problems in cities. In general, numerical simulations can provide specific detailed informations of flow, turbulence and dispersion. To deal with small-scaled flow and dispersion, computational fluid dynamics (CFD) models are widely applied and are capable of reproducing small-scaled characteristics of flow and dispersion. A CFD model-FLUENT was adopted to simulate the disturbance of a single building on atmospheric flow under the neutral stability condition. Wind tunnel data published by Hamburg University was collected to validate the modeled results and assess the choices of parameters and parameterization schemes. This technique was applied to address atmospheric dispersion problems in quasi-urban building arrays. Concentration data of MUST and a tracer experiment were used to evaluate the dispersion modeling. The results indicated that FLUENT well performed in mean flow simulation under construction disturbance condition. Simulated results for FAC2 of horizontal and vertical modeling wind speed were 77.9% and 61.0% respectively. However, thre was a relatively larger discrepancy between the modeling and measured turbulence characteristics, when the FAC2 of modeling turbulent kinetic energy was 54.6%. The turbulent closure scheme options (i.e., standard K-ε scheme, Re-normalization Group K-ε scheme and Reynolds Stress Model scheme) had trivial effects on simulated results. The dispersion simulation case within quasi-urban buildings was satisfactory. The result of the dispersion case correctly reproduced the irregular plume shifting caused by building disturbance compared to the average wind direction. The modeling concentrations were generally in accordance with measured results, and the relative tolerance of the modeling maximum concentration in lateral profile at 32 and 63 m downwind were 72.5% and 36.9% respectively. Relative to the Gaussian plume model-ISC3, FLUENT can provide more practical concentration distribution under complex conditions. FLUENT simulation also indicated that the maximum lateral concentration decreased along the downwind direction in "step change" pattern between the adjacent street canyons near the release source. The maximum lateral pollutant concentrations in the same street canyon as the source were several times or even one order of magnitude higher than that in the next canyon. FLUENT results can reproduce the phenomena of dispersion towards upwind area and also of accumulation and detouring flow around the constructions. Further researches are required to analyze the phenomena.

Study on Thermal Environment and Pollutant Dispersion in Real Urban Area by Large Eddy Simulation

Large eddy simulation of city micro-atmospheric environment

Flow Patterns and Heat Transfer of an Idealized Square City in Non-Uniform Heat Flux and Different Background Wind Conditions

Study on micro-atmospheric environment by coupling large eddy simulation with mesoscale model

Large Eddy Simulation of traffic pollutant dispersion in a residence area

LARGE EDDY SIMULATION OF WIND FIELD AND TRAFFIC POLLUTANT DISPERSION IN A RESIDENCE AREA

Research Advances in Large Eddy Simulation of Urban Atmospheric Environment

Large Eddy Simulation of the Wind Field and Pollution Dispersion in Building Array

Large Eddy Simulation of Wind Field and Pollutant Dispersion in Downtown Macao

Large Eddy Simulation of Urban Heat Island Phenomenon

Numerical Simulation of Micro-Environmental Flow Around City Resident Sub-Districts

Numerical Simulation of Micro-Atmospheric Environment by Les in A District of Beijing

A Composite Model for Complex Building Street Configuration in a Large Eddy Simulation of Local Urban Atmospheric Environment

Large Eddy Simulation of Unstably Stratified Turbulent Flow over Urban-Like Building Arrays

Numerical simulation of urban heat island evolution and its effect on pollutant transport

Three-dimensional modeling of air flow and pollutant dispersion in an urban street canyon with thermal effects

Numerical simulation of airflow and dispersion in 3D street canyons: The effect of atmospheric temperature stratifications

Numerical Simulations of Air Flow and Traffic–Related Air Pollution Distribution in a Real Urban Area

CFD Simulations of Flow and Dispersion under Construction Disturbance Conditions

Large Eddy Simulation of Pollutant Gas Dispersion with Buoyancy Ejected from Building into an Urban Street Canyon

Study on the Wind Environment and Pollution Diffusion of Building Group Based on LES Staggered Joint Arrangement