Study on Preparation Technology of Granules Containing Polysaccharide Parts of Sagittaria sagittifolia

Xiuli WANG,Jing WANG,Chunguo WANG,Xinyi WANG,Xiuhui KE,Bing LI,Yan LIAO

DOI: https://doi.org/10.13313/j.issn.1673-4890.2017.11.024

2017-01-01

Abstract:Objective:To optimize the extracting process of polysaccharide parts in Sagittaria sagittifolia and the preparing process of granules with such parts,in order to provide the experimental basis for the development and utilization of such parts.Methods:Taking extract yield as the evaluation index,the L4 (23) table of orthogonal design was applied to optimize the extracting process of polysaccharide parts in S.sagittifolia and such parts were prepared.The content of polysaccharide in the extraction was determined by phenol-sulfuric acid method.Then,taking moisture absorbability,formability,solubility,angle of repose and difficulty degree of granulation of the prepared granules as evaluation indices,the L9 (33) table of orthogonal design was used to optimize the preparing conditions of granules with the extraction prepared above.Angle of repose,determined by the fixed funnel method,was applied to select the optimized forming process of the granules considering the impact of addition of auxiliary materials,the proportion of polysaccharide parts with auxiliary materials and the concentration of ethanol.Results:Extracting S.sagittifolia for 48 hours by cold leaching 6 times the amount of 70％ ethanol was the optimized extracting process.The content of polysaccharide in such extraction was 20.22％.The optimized forming process of the granules was using lactose as the auxiliary material,which was mixed with the extraction in a ratio of 2∶1,and using 80％ ethanol as wetting agent.These prepared granules had good particle formability,fluidity,anti-adhesion and dissolvability,whose solution was without precipitation after still standing.Conclusion:The optimized extracting process of polysaccharide parts in S.sagittifolia and the preparing process of granules with such parts are reasonable,simple and feasible,which provide the experimental basis for the development and utilization of such parts.