Abstract:Purpose: To evaluate the shear bond strength (SBS) of resin composite to dentin contaminated with artificial saliva (AS) containing mucin and amylase using an experimental method controlling the volume of saliva and adhesive in a defined surface area. Methods: Flat bonding surfaces were prepared on extracted human molars (320 grit surface). Using adhesive tape, a 4.5 mm bonding window was prepared on the dentin surfaces. Groups (n= 12) were prepared using the etch & rinse (ER) or self-etch (SE) modes for Adhese Universal (ADH), Scotchbond Universal Plus (SBU), and Prime & Bond active (PBA) dental adhesives (DA). For the control (C) groups, the adhesives were applied per the manufacturers' instructions with 2.0 µl or 3.0 µl of the adhesive. For the saliva-contaminated groups, 1.0 µl of artificial saliva with mucin was applied in the bonding window either dried or allowed to remain wet before the application of either 2.0 µl or 3.0 µl of the adhesive. After the adhesive film was air dried and light cured using an Ultradent bonding fixture, Spectrum TPH3 was bonded to the prepared surfaces. After water storage for 24 hours at 37°C, the specimens were debonded and shear bond strength (SBS) was calculated (MPa). A Kruskal-Wallis test with Bonferroni correction was used to determine group differences (P< 0.05). Scanning electron microscopy (SEM) was performed to visualize the interfacial surfaces prepared using an ion-etching technique. Results: Mean SBS for the three adhesives were similar in both ER and SE modes to uncontaminated dentin surfaces for all the control groups. For dentin contaminated with dried or wet saliva, both the surface condition and the adhesive system were significant factors at a confidence level of 95%. For the dried saliva test groups, ADH and PBA with 3.0 µl of adhesive generated similar SBS values to controls while SBU generated lower values. Lower values were generated when using 2.0 µl of adhesive for the three adhesives in SE and ER modes except for PBA in the ER mode. Using wet saliva and 3.0 µl of adhesive ADH and SBU generated lower SBS values while PBA generated similar values to controls. Under SEM, morphology at the adhesive dentin interfaces was similar among the adhesives to uncontaminated dentin but notable differences were observed for SBU and ADH for both wet and dried saliva-contaminated surfaces. Clinical significance: Salivary contamination differentially affects shear bond strength and the morphology of the bonded interface of universal adhesives to dentin. These differences are specific to the adhesive tested and are influenced by using the etch and rinse or self-etch strategies and the volume of adhesive used. When concerned about salivary contamination clinically, maximizing the volume of adhesive on the substrate may help mitigate the deleterious effects of saliva contamination.

Effects of the Ph of Artificial Saliva on Potential of the Dental Surface--An In-vitro Study

The Effect on the Corrosion Resistance of Ti Alloy in the Artificial Saliva with Different pH Value

An electrochemical study on corrosion behavior of three alloys in artificial saliva with different pH

Effects of Saliva Contamination on Bonding Performance of Self-Etching Adhesives

Effect of xylitol chewing gum on dental plaque pH in vivo

Analysis of the Effects of Different Orthodontic Appliances on Salivary pH Levels: An In vitro Approach

The Measurement of Contact Angle, pH, and Conductivity of Artificial Saliva and Mouthwashes on Enamel, Glass-Ionomer, and Composite Dental Materials

Evaluating the Effect of Different Mouthrinses on Properties of the Enamel and Dental Composite Surfaces

Effect of pH and titratable acidity on enamel and dentine erosion

Effect of Ph Value and Fluoride Ions on Corrosion Resistance of Pure Ti and Ni-Cr-Ti Alloy in Artificial Saliva

Dental plaque pH recovery effect of arginine bicarbonate rinse in vivo.

Effects of Phosphoric Acid Pre-Etching on Chemisorption between Enamel and MDP-Containing Universal Adhesives: Chemical and Morphological Characterization, and Evaluation of Its Potential

Effect of acid neutralizer toothpaste on salivary pH in a group of Egyptian children: A randomized controlled pilot study

Effect of Using Mouthwash Containing Cibotium barometz J. Smith on Cariogenic Bacteria and Acid-producing Ability of Saliva: A Randomised Blinded Clinical Trial

The Effect of Oral Care Foams and a Spray on Salivary pH Changes after Exposure to Acidic Beverages in Young Adults

To assess the effect of selected locally available beverages on salivary pH, flow rate, and oral clearance rate among adults

Synergistic Effect of Wire Bending and Salivary Ph on Surface Properties and Mechanical Properties of Orthodontic Stainless Steel Archwires

Influence of apple juice on human enamel surfaces of the first and second dentition - an in vitro study

Effects of some commercial calamansi-containing beverages on the enamel surface

Effect of Saliva on the Tensile Bond Strength of Different Generation Adhesive Systems: An In-Vitro Study

Effects of salivary contamination on the shear bond strengths of universal adhesives to dentin