Abstract:OBJECTIVE:To investigate the changes of the vertical height and width of the alveolar bone six months after the alveolar ridge preservation in periodontal compromised molar sites of severe alveolar bone defects with clinical direct measurement, parallel periapical radiographs, and cone-beam computed tomography (CBCT), and to analyze the effect of the three different methods of measurement. METHODS:In this study, 20 subjects requiring tooth extraction on account of periodontal disease with a total of 23 extracted molars were enrolled. Extractions were performed atraumatically and patients were received alveolar ridge preservation procedure with Bio-Oss and Bio-Gide. Clinical direct measurements were taken after tooth extraction and during the implant surgery 6 months later, CBCT scans and parallel periapical radiographs were taken immediately after ridge preservation and 6 months later. The changes of alveolar ridge width and vertical height after six months were measured and analyzed through the above-mentioned three methods and the similarities and differences of the measured effect were compared. RESULTS:There were no significant difference of alveolar vertical height in the center of the extraction sites, the center of distal aspect, and distobuccal aspect between the clinical direct measurements and the CBCT measurements (P>0.05), alveolar vertical height in other points and alveolar width measurements were statically significant (P<0.05). After 6 months, 10 sites of 10 subjects were received a flap and re-entered to perform dental implants surgery. The vertical height in the center of alveolar increased significantly and the changes of alveolar vertical height of clinical direct and CBCT measurement were (6.15 ± 1.73) mm and (6.59 ± 2.53) mm, respectively. The measurements of the width of the alveolar bone were (8.45 ± 1.18) mm and (8.52 ± 1.27) mm, respectively. The measurements of the two methods were not statistically significant (P>0.05). The change of the alveolar height in the center of the extraction socket after six months measured by parallel periapical was (5.84 ± 4.28) mm, which was closed to the clinical direct measurement and the CBCT measurement. CONCLUSION:Clinical direct measurement and CBCT measurement were largely consistent in the evaluation of the alveolar bone height and width after the alveolar ridge preservation using deproteinized boving bone mineral (DBBM, Bio-Oss) and bioabsorbable collagen membrane (Bio-Gide) in periodontal compromised molar sites of severe bone defects.

Clinical study on the quantitative analysis of ABG with the application of CBCT

Facial alveolar bone alterations and gray value changes based on cone beam computed tomography around maxillary anterior implants: A clinical retrospective study of 1-3 years

Evaluation of the clinical efficacy and safety of modified alveolar cleft bone graft with cone-beam CT digital imaging in children

Evaluation of alveolar bone grafting using limited cone beam omputed tomography

Evaluation of alveolar bone grafting using limited cone beam computed tomography

Progressive Comparison of Density Assessment of Alveolar Bone Graft in Patients with Unilateral and Bilateral Cleft

The Comparison of Occlusal Radiograph and CBCT in the Evaluation of the Alveolar Bone Grafting

[Measurement of the Volume Absorption of Alveolar Bone Grafting].

A New Method to Standardize CBCT for Quantitative Evaluation of Alveolar Ridge Preservation in the Mandible: a Case Report and Review of the Literature.

CBCT subtraction analysis of 3D changes following alveolar ridge preservation: a case series of 10 patients with 6-months follow-up

The Comparison of Two-Dimensional and Three-Dimensional Methods in the Evaluation of the Secondary Alveolar Bone Grafting.

[The role of CBCT in evaluation of alveolar bone state during orthodontic-periodontal treatment].

Initial Study and Evaluation on Alveolar Bone Graft by Palate Side Approach

[Evaluation with Different Measuring Methods for the Alveolar Bone Change of Ridge Preservation in Molar Sites].

Application of CBCT in evaluation of alveolar bone changes before and after periodontal therapy in chronic periodontitis

Postoperative Assessment of Secondary Alveolar Bone Grafting Using a Combination of β-Tricalcium Phosphate and Chin Bone for Patients With Unilateral Cleft Alveolus

Technology improvement and the preliminary evaluation of alveolar bone graft

A Concise and Accurate Method for Evaluating Alveolar Cleft ReconstructionDiet al Concise and Accurate Method for Evaluating

A Novel Semiautomatic Technique for Volumetric Assessment of the Alveolar Bone Defect Using Cone Beam Computed Tomography

[Evaluation of Bone Volume of Alveolar Cleft Before and after Bone Graft].

Application research of dental implant in posterior area of maxillary and mandible using CBCT and digital orthopantomography